Table of Contents
Advertisement
Step 3: Attach the Integrated Panel to the
Drawer
1. Set the integrated panel on drawer front face and align
edges. (See Figure 17). The custom integrated panel
should be flush with the top of the drawer and centered
on the width of the drawer. Clamp panel in position and
mark pilot hole locations. Pick the required pilot hole
size from "Table A" below and drill the pilot holes ensur-
ing not to drill all the way through the integrated panel.
Table A: Pilot Hole Drill Sizes for Wood Screws
Material Type
Hardwood
Softwood
2. Insert wood screws through clearance holes and
tighten to secure integrated panel.
3. Reinstall gasket into channel. Make sure the corners
are fully inserted.
4. Place the drawer divider back into the drawer.
Figure 23
INTEGRATED PANEL INSTALLATION
#8 Wood Screw
⁄
Diameter Pilot Hole
1
8
⁄
Diameter Pilot Hole
7
64
Screw clearance
hole through
gasket extrusion
Figure 23a
Integrated panel
flush with top
edge of drawer
Using clearance holes in
gasket channel mark
hole locations onto panel
Custom integrated
panel to be cen-
tered on width of
drawer.
17
Advertisement
Table of Contents
