Replacement Of Water Cooled Condenser; Replacement Of Compressor - Scotsman ACM 45 Service Manual

Page 29
R. REPLACEMENT OF WATER COOLED
CONDENSER
1. Remove front and rear panels.
2. Remove bolts which secure the condenser
to the unit base.
3. Remove the corbin clamps and disconnect
the plastic hoses from the water cooled
condenser.
4. Recover the refrigerant from the system
and transfer it in a container so to reclaim or
recycle it.
5. Unsolder the refrigerant lines from the
condenser and remove it from the unit.
NOTE. Always install a replacement drier
whenever the sealed refrigeration system is
open.
Do not replace the drier until all other repairs
or replacements have been completed.
6. To install the replacement condenser follow
the above steps in reverse.
NOTE. Thoroughly evacuate the system to
remove moisture and non condensables after
condenser replacement.
S.

REPLACEMENT OF COMPRESSOR

1. Remove front and rear panels.
2. Remove the cover and disconnect the
electrical leads from the compressor junction
box.
3. Recover the refrigerant from the system
and transfer it in a container so to reclaim or
recycle it.
4. Unsolder and disconnect both the suction
line and the discharge line from the compressor.
5. Remove the four compressor mounting bolts
and the compressor from the unit base.
NOTE. Always install a replacement drier
whenever the sealed refrigeration system is
open.
Do not replace the drier until all other repairs
or replacements have been completed.
6. To install the replacement compressor follow
the above steps in reverse.
NOTE. Thoroughly evacuate the system to
remove moisture and non condensables after
compressor replacement.
Page 29