ABB TZIDC-210 Operating Instructions Manual page 13

Follow the procedure (steps 1 - 5) below to attach the positioner to a linear
actuator:
1. Mount the follower guide to the actuator
1
4
Fig. 5 Mounting follower guide to actuator
2. Assemble the lever (if not yet pre-assembled)
Fig. 6 Assembling the lever
42/18-81 EN
2
3
7
8
9
3
2
1
Electro-pneumatic positioner TZIDC-210
• Fasten the follower guide (1)
and the clamp plates (2) with
screws (4) and spring washers
(3) to the spindle of the actua-
tor; hand-tighten the screws.
• Slip the spring (2) onto the bolt
with the follower pin (1).
• Slip the plastic washer (3) onto
the bolt and compress the
spring with it.
• Insert the bolt with compressed
spring into the oblong hole in
the lever (4) and fasten it in the
desired position using the plain
washer (5) and nut (6) at the
lever; the scale on the lever
6
indicates the link point for the
stroke range.
5
4
• Slip the plain washer (8) onto
the screw (7), insert the screw
into the lever and counter with
the nut (9).
13