Profi-Partner 50222 Manual page 8

Note: please fully charge the device via the supplied USB-C charging cable before using it for
the first time. The device cannot be used while charging.
Power indicator: Flashing red = Charging. Blue = Charged.
Use with 12V connection for charging and filling
You can charge the unit with the 12V connection of your vehicle, cable included. In this mode
it is also possible to operate the pump at the same time. Proceed as follows:
1) Start the car.
2) Plug the 12V car charger cable into the car's cigarette lighter and connect the power cable
to the pump. Connection ❽.
3) Connect the air hose to the pump ❿ and tighten it well. Make sure that the sealing ring is
present and properly positioned, otherwise the performance will be affected.
4) Connect the air nozzle to the tyre valve. If using one of the other adapter heads, screw it
tightly beforehand and then attach it to the valve.
5) A long press (approx. 3 sec) on the "M" button "wakes up" the display.
6) Select one of the pre-set applications (car, motorbike, bicycle, ball, free input) by quickly
pressing the mode button ❷. The air pressure indicated then serves as a guideline. You can
change this individually using the + and - buttons. After setting, the display flashes twice and
then shows the current tyre pressure.
(KPA/BAR/PSI/KG/cm2)
To select another unit of air pressure press and hold the mode button
❷ for slightly longer. Repeat the procedure until you get the desired unit in the display.
7) Press the "M" button ❻ to start the air pump. After reaching the previously entered or
predefined air pressure, the pump stops pumping – auto stop function.
8) Close the screen display by a long press of the "M" button or wait about 40 seconds, then
the display turns off automatically.
In dark surroundings or emergency situations, an additional LED light with 3 modes is available
– regardless of whether you are using the pump at the same time or not. Press the button
with the light symbol ❹ a little longer to start or stop the light function. Press more quickly
to switch between the individual modes. Note: the light function can also be started when the
screen is off.
8