Functional Description - Makita DAS180Z Instruction Manual

Installing optional filter
Optional accessory
An optional high performance filter (Filter C) is available
for restricting dust intake into the motor under dusty
working conditions.
1.
Turn the dust cap on the suction inlet at the rear of
the housing counterclockwise to take the dust cap out
of the housing. Two locking tabs on the dust cap can be
disengaged by aligning them with the guide grooves on
the housing.
Fig.14
► 1 . Dust cap 2. Locking tabs 3. Suction inlet 4. Guide
grooves
2.
Replace an optional high performance filter on
the suction inlet, aligning the two locking tabs on the
optional filter with the guide grooves on the housing.
Then turn the optional filter clockwise to secure it in
place.
3
Fig.15
► 1 . Optional high performance filter 2. Locking tabs
3. Suction inlet 4. Guide grooves
1
3
4 2
4
2
1
NOTICE:
An optional high performance filter
(Filter C) can be reused many times by cleaning it
out. Clean dust off the filter regularly as a clogged
filter may block the airflow and cause less effi-
cient operation. Occasionally wash the filter in
water, rinse and dry thoroughly in the shade
before use.
NOTICE:
Do not wipe, rub or scratch an optional
high performance filter (Filter C) hardly. Be sure
to shake or blow dust off the filter with care.

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before adjusting or checking function on the tool.
Installing or removing battery
cartridge
CAUTION:
Always switch off the tool before
installing or removing of the battery cartridge.
CAUTION:
Hold the tool and the battery car-
tridge firmly when installing or removing battery
cartridge. Failure to hold the tool and the battery
cartridge firmly may cause them to slip off your hands
and result in damage to the tool and battery cartridge
and a personal injury.
1
2
Fig.16
► 1 . Red indicator 2. Button 3. Battery cartridge
To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator as
shown in the figure, it is not locked completely.
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
it may accidentally fall out of the tool, causing injury to
you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
13 ENGLISH
3