Advertisement
PILOT SHIELD
BURNER ASSEMBLY
4836 & 6048
BURNER ASSEMBLY
7260 & 8472
Figure 1. Base Pan with Burner and Pilot Cover
Figure 2. Remove Screws on Bottom Glass
2
Heatilator • ALK-36, ALK-48, ALK-60, ALK-72 Installation Instructions • 2300-947 Rev. J • 3/18
MEDIA TRAY
INSTALLATION
1. Place LED Tray Assembly into appliance through the
bottom glass opening.
2. Secure the LED power supply with two screws.
3. Attach the AUX to the component tray with velcro.
Refer to Figure 4 and Figure 5 for the following steps:
4. Plug the light wire harness into the LED power supply.
5. Plug the LED power supply into AUX2 on the AUX
module.
6. Using self-tapping screws, secure green ground wire of
cord assembly to component tray.
7. Plug the AUX module into the junction box and control
module.
8. Place wires in wire management clips to prevent touch-
ing the firebox.
9. Reinstall the bottom glass, burner, pilot and media tray.
10. Place media according to instructions include with me-
dia kit.
11. Reinstall glass assembly.
12. Plug the 6V transformer into the junction box.
13. Reinstall component heat shield.
CAUTION! Risk of Overheating! Component heat shield
MUST be installed before operating appliance. Electrical
components will be damaged.
14. Turn on gas and electric power to appliance.
Model Size 36/48/60/72
Figure 3. LED Tray Assembly in Position
COMPONENT
HEAT SHIELD
CONTROL MODULE
AUX
BATTERY
TRAY
Figure 4. Electrical Components in Position
JUNCTION BOX
LED POWER
SUPPLY
Advertisement
