Parkside PMRA 20-Li A1 Instructions Manual page 57

Cutting motor blocked
Left motor blockage
Please replace the
battery
Battery abnormal
Battery damaged
Battery temperature too
low (discharge)
Battery voltage too high
Battery High temperature
High charging current
High charge voltage
High temperature
Mower lifted
Mower upside down
Mower stuck
Mower tilted
Motor overtemperature
Motor error
EM sensor not
connected
Hall sensor failure
Hardware error
Charge abnormal
Discharge abnormal
Battery discharge error
Inertial measurement
unit (IMU) error
Motor error
Motor switched off
Motor Hall sensor error
Motor overcurrent
Motor blocked
Motor standstill right
Rain sensor failure
Loop sensor failure
see chapter "Removing blockages"; check blade for foreign
objects/defects;
If necessary, contact manufacturer (see "Service Centre")
Replace battery
Cancel charging process
Battery voltage too high
Battery has a high temperature
Cancel charging process, check input current
Cancel charging process, check input voltage
Cancel charging process
Lawn mower was lifted
Set lawn mower upright and restart
Clear the lawn mower and restart
Set lawn mower upright and restart
Switch off the lawn mower and let it cool down
Contact manufacturer (see "Service Centre")
GB MT
57