NENKO 19772095 Quick Start Manual

1. Name of the product

Nenko Interactive – Bubbel tube 100 x15 cm

2. Product code

19772095

3. Colour

As pictured

4. Description

Bubble units are essential in any multisensory room or sensory area. Our bubble units are:
- visually attractive due to the changing, coloured light
- soothing by the movement of the bubbles
- relaxing due to the heat and vibration of the tube
- maintenance-friendly due to LED lighting
With LED lighting for maintenance-free use. Works on 220 volts. About 18 liters of water go into this
bubble unit.

5. Included

1 x Bubbelunit
6. Sensorystimulations
See

7. Commissioning

1. Before the bubble unit can be put into use, it must be on a fixed, non-sloping surface.
2. Then carefully unpack the bubble unit.
3. By filling 1/2 liter of demineralised water, check that the hose connection and the bubble
unit are waterproof.
4. Fill the tube up to a maximum of 40 mm from the top edge.
5. Please note! When filling, no water should run out from under the bubble unit.

8. Technical information

Size: 15 x 100 cm
Power supply: 220V

9. Maintenance

•
The plexiglass tube should only be cleaned with a damp cloth (do not use detergent!)
•
Due to evaporation of the water, it is normal to refill the tube regularly.
•
Over time, the water may become cloudy, then empty the entire tube, clean it thoroughly
and refill again.
•
We recommend using a bubble unit pump. You simply hang the pump in the tube, put the
other end (the tube) in a bucket and you turn on the pump. Be careful that you empty the
bucket in time!