Summary of Contents for austriamicrosystems AS3610-AN01-Demoboard
Page 1
AS3610 – AN01 - Demoboard Preliminary Application Note – USB complient Step down Charger for Portable Devices Preliminary Application Note AS3610-AN01-Demoboard 1V0 USB complient Step down Charger for Portable Devices 1 General Description The AS3610 is highly integrated standalone or optional I2C controlled step down charger.
After that, follow the following sequence to connect the AS3610 Board: (also shown in the picture below) Connect the an USB cable or alternative supply the board from a power supply (5V) Connect the austriamicrosystems AG USB BOX at J1 connect a battery to VBAT and GND A red LED (D2) on the Board immediately indicates a proper connection of the power supply.
3 Charging=ON, stop_charging or boost_error=5Hz blinking Overview which current can be selected 4 Charging=ON, EOC=1Hz blinking, stop_charging or on the Demoboard boost_error=5Hz blinking 5 ch_det =ON, EOC=1Hz blinking, stop_charging or boost_error=5Hz blinking www.austriamicrosystems.com (mmt) Revision 1.0 / 2010/07/27 4 - 12...
Register of Charger Status now should be set: ChDet and it is depending on the battery voltage CCM or Trickle or Const. Volt. Mode or EOC is shown. Disconnect battery : CHDet & EOC are set www.austriamicrosystems.com (mmt) Revision 1.0 / 2010/07/27 5 - 12...
Page 6
Re-connect Battery and Jumper Disable in the SW the “ USB charger enable” Disconnect VBUS Activate the “ Boost Enable” LED D2 is turned on! The Voltage on Vbus is ~5V. www.austriamicrosystems.com (mmt) Revision 1.0 / 2010/07/27 6 - 12...
5V supply VBAT Battery connector Device Value comment USB complient Step down Charger for Portable Devices AS3610 USB connector 5V supply for Vbus Connector and Jumper locations of AS3610A Demoboard 1V0 www.austriamicrosystems.com (mmt) Revision 1.0 / 2010/07/27 7 - 12...
The information furnished here by austriamicrosystems AG is believed to be correct and accurate. However, austriamicrosystems AG shall not be liable to recipient or any third party for any damages, including but not limited to personal injury, property damage, loss of profits, loss of use, interruption of business or indirect, special, incidental or consequential damages, of any kind, in connection with or arising out of the furnishing, performance or use of the technical data herein.
Need help?
Do you have a question about the AS3610-AN01-Demoboard and is the answer not in the manual?
Questions and answers