VDD Supply from I / O Interface Connector “D” Address Bit 0: logic “0” Self Addressing Bit 0 Address Bit 0: logic “1” Address Bit 1: logic “0” Self Addressing Bit 1 Address Bit 1: logic “1” www.austriamicrosystems.com Revision 1.04 2 - 7...
Page 3
Remove Jumper to simulate an open circuit. Short Circuit Set Jumper to simulate a short circuit. Measurement Points Description Label Name Description Info Interrupt Request Serial Clock Input Measurement Points Serial Data I/O Ground Power Supply www.austriamicrosystems.com Revision 1.04 3 - 7...
Page 4
I/O Connector “D”. If no controller is available the austriamicrosystems USB box in combination with the AS1115 White Goods Demoboard software can be used as well. This USB box is needed to set-up the connection between the demoboard and the USB interface of a PC.
White Goods Operational sequence If not present get the datasheet for the AS1115 from www.austriamicrosystems.com. Use the IC on the demoboard only with the recommended settings and values as described in the datasheet. First connect the Power Supply (+2.7V to +5.5V) to the demoboard (VDD “A” and GND “B”) and than power up the controller (I/O Interface “D”).
The information furnished here by austriamicrosystems AG is believed to be correct and accurate. However, austriamicrosystems AG shall not be liable to recipient or any third party for any damages, including but not limited to personal injury, property damage, loss of profits, loss of use, interruption of business or indirect, special, incidental or consequential damages, of any kind, in connection with or arising out of the furnishing, performance or use of the technical data herein.
Need help?
Do you have a question about the AS1109 and is the answer not in the manual?
Questions and answers