Before First Use - Nac RLM1500G2-NG Manual

using the device for purposes other than those described in the manual,
when other people, especially children or animals, are nearby,
use of the device by people not familiar with the manual,
using the device without proper protective clothing and footwear for the operator,
using the device with damaged covers or housing and without properly installed safety devices.
By observing the recommendations given in the operating manual, the residual risk of using the device can be eliminated.
There is a risk of not following the above recommendations.
APPLICATION
The device is intended only for mowing lawns in accordance with the description and safety rules contained in this manual
using. Any other use may be dangerous for users and may damage the equipment. The machine
should not be used, for example, for:
- collecting leaves or clearing the area of dry plants,
- leveling molehills,
- trimming shrubs,
- shredding the branches.

BEFORE FIRST USE

Read this manual and the structure of the device.
Make sure that the mains voltage corresponds to the voltage recommended on the charger nameplate.
.
Construction and description of a lawn mowing robot
. Planning
.
Sketch of the canvas
In order for the robot to mow the desired area - you need to mark this area with a link for marking the working area. Before
starting, it is recommended to make a sketch of the robot's working area and the "obstacles" that the robot should avoid. The
area in which the robot should work should be marked with a boundary line.
Objects that the robot should avoid should also be marked.
During operation, the robot must constantly detect the presence of the boundary wire in order not to lose the signal. The distance of the robot to the nearest
boundary wire must not exceed 15 m(Fig. 3).
If another lawn mower is working in the vicinity, it is important that the distance between their working areas is at least 1 m to
avoid interference between wired signals.
In addition, it is important to install the Docking Station at least 1 m away from the boundary wire of the other robot. To
avoid problems in the future, please follow the sketch carefully to lay the boundary wire correctly. An example of a sketch
of the working area is shown below onFig. 3.
1. Docking station
2. Robot for mowing grass
3. Link to mark the
working area
4. Stakes for fastening the rope
5. A set of knives
6. Screws for fastening the station
docking station
7. Charger
9