Cleaning, Maintenance And Storage - Nac RLM1500G2-NG Manual

. Safe mode and reset
While working, the robot may encounter an unforeseen event that will trigger the emergency mode. Such events include, among others:
too high an inclination, one of the robot's wheels driving into a hole, the robot colliding with an obstacle, the robot is lifted. As a result of
such an event, the robot stops working and goes into emergency mode. An appropriate message will be displayed on the robot's screen
(see. "Robot status and error messages ").
To restore the robot in emergency mode, the following conditions must be met:
- remove the obstacle that caused the failure,
- place the robot on the boundary wire.
Reboot
To start the robot in safe mode, enter the PIN code and press the button START.
ATTENTION! If the robot shuts down, it has to be restarted on the docking station.
.
Battery discharge
After the battery is discharged, the robot must drive to the docking station. If the robot encounters a marked obstacle, it will drive around it and if it does not
find the docking station, it will go to the next boundary wire to reach the docking station.

CLEANING, MAINTENANCE AND STORAGE

After finishing work, the device should be cleaned of remnants of grass, dust and dirt.
ATTENTION! Always make sure the device is turned off and disconnected from the power supply (battery is removed) before carrying out
inspection or maintenance.
Using a delicate brush, brush or cloth, clean the housing of dust, you can clean the robot with compressed air.
It is permissible to clean it with a damp cloth, but only if the device is dried immediately afterwards. Metal parts
should be protected with oil.
Regularly clean the air vents with compressed dry air. Do not insert sharp objects into the ventilation openings.
After completing the work:
Wipe vents and leave free of debris.
Wipe the robot with a dry cloth.
Both the casing and the underside of the lawn mower should be cleaned.
The docking station also requires cleaning and maintenance, especially when the robot has come into contact with wet or very lush grass.
ATTENTION! Never use aggressive or corrosive detergents for cleaning as they may damage the plastic parts of the device.
It is unacceptable to wash the robot with a water jet, water may damage the electrical parts of the machine.
Cleaning agents and solvents such as gasoline, carbon tetrachloride, chlorinated cleaning solvents, ammonia, and household
detergents that contain ammonia can damage plastic components.
ATTENTION! Store the lawn mower in a well-ventilated room in a dry, dust-free place. Only keep the device in
working condition; Before storing, faults must be removed.
Cutting blades replacement
Before replacing the cutting blades, power off the lawnmower and wear protective gloves. Turn the robot over
and remove any foreign objects such as grass that has accumulated around the blade disc. The blades should be
checked regularly every month and replaced as soon as they wear out.
To replace the blade, unscrew the screws, remove the worn blades, put in new blades and tighten them with
screws. Make sure the blades can rotate and work properly.
Prepare the battery for recycling
Secure the battery terminal with heavy-duty insulation tape.
ATTENTION! Do not attempt to destroy or disconnect the battery or remove any of its components.
Keep out of the reach of children.
Failure to follow the above precautions may result in fire and / or serious injury.
16