Advertisement
WINDHAM
wall
strap
plastic
anchor
C
wall
bracket
D
10 Safety Mounting Instructions
For added safety and stability, it is recommended that the wall
mounting hardware be installed. For safe mounting, it is
essential to use wall anchors appropriate to your wall type (i.e.
plaster, drywall, concrete, etc.). Mount to wood studs
whenever possible.
A) Attach anti-tip bracket to top of media stand using 2 small
screws as shown.
B) Determine the final location of media stand. Mark position
on the wall, approximately 2" below the anti-tip bracket
mounted to the back of the media stand.
C) Drill a hole in the wall stud. If the wall stud is not available,
drill a hole in the wall that is slightly smaller in diameter than
the anchor. Gently tap the plastic anchor until the flange of
the anchor is flush with the wall.
D) Attach the wall bracket to the wall by inserting 1 large
screw through the wall bracket and into the wall anchor in the
wall.
E) Place the unit so the anti-tip bracket on the back edge is
allowed with the wall bracketl.
F) Lace one end of the wall strap through both brackets, and
into the other end of the strap.
G) Pull the strap tightly until secure.
Repeat steps A-G for remaining anti-tip and wall bracket.
Made in China - r05
CORNER MEDIA STAND
A
small
screw
F
anti-tip
bracket
large
screw
Customer Service 800.967.6696 | www.crateandbarrel.com
NOTE:
If you are unsure about your wall type or what
mounting method you should use, consult a
qualified professional or your local hardware
store.
Page 5 of 5
Advertisement
