CAMPBELL SCIENTIFIC, INC. CAMPBELL SCIENTIFIC, INC. will return such products by surface carrier prepaid. This warranty shall not apply to any CAMPBELL SCIENTIFIC, INC. products which have been subjected to modification, misuse, neglect, accidents of nature, or shipping damage. This warranty is in lieu of all other warranties, expressed or implied, including warranties of merchantability or fitness for a particular purpose.
Page 3
5.6 Crossarm Attachment................14 5.7 Enclosure Attachment ................14 6. Mounting Brackets............17 6.1 CM210 Crossarm-to-Pole Mounting Kit..........18 6.2 CM215 Sensor Mounting Kit for Top of Mast of CM110, CM115, or CM120....................19 6.3 CM220 Right Angle Mounting Kit ............20 6.4 CM225 Mounting Stand .................21 6.5 CM230 Adjustable Angle Mounting Kit..........22...
Page 4
Tripod Installation Table of Contents 5-3. Mast Attachment to Tripod Base ............6 5-4. Mast Lock Bracket.................. 8 5-5. Upper Guy Ring..................9 5-6. Guy Hook and Lever Arm..............10 5-7. Mechanical Drawing of Guy Hook and Case........11 5-8. Staking the Tripod Feet................. 11 5-9.
Page 5
UV-resistant cable ties for securing cables. A guy kit is included with the CM115 and CM120 models, and is an option for the CM110. A durable Tripod Tote Bag is also available as an option.
(6) stakes. The ground rod clamp, lightning rod, and grounding wires are enclosed in a bag. The guy kit (optional for the CM110), and tripod tote bag (optional) are packaged separately. The CM115 and CM120 tripods include additional mast sections.
Tripod Installation Manual Models CM110, CM115, CM120 5. Tripod Installation 5.1 Tripod Base WARNING Tripod installation near power lines is dangerous. The minimum safe recommended distance from overhead power lines is 2 times the height of the tripod and mast combined.
Page 9
Tripod Installation Manual Models CM110, CM115, CM120 5.2 Mast The CM110, CM115, and CM120 have one, two, or three mast sections respectively. The bottom mast section has two hanger brackets for attaching an instrument enclosure. The top of each mast section has an insert that needs to be extended above the mast.
Page 11
Tripod Installation Manual Models CM110, CM115, CM120 Additional mast sections are installed with the bottom section tilted down in the horizontal position. Attach additional sections by sliding the bottom of a mast section over the insert of a lower section, aligning the holes and installing the 5/16”...
The CM115 and CM120 tripods include a guy kit; the guy kit is an option for the CM110. With the mast tilted down in the horizontal position, slide the guy ring over the mast insert as shown in Figure 5-5. Return the mast to the upright position and install the locking bracket.
Page 14
Tripod Installation Manual Models CM110, CM115, CM120 FIGURE 5-6. Guy Hook and Lever Arm...
Tripod Installation Manual Models CM110, CM115, CM120 load end dead end Phillips screw lever hook FIGURE 5-7. Mechanical Drawing of Guy Hook and Case 5.4 Staking the Tripod Feet Six stakes are provided for securing the tripod feet to the ground. Drive two stakes through holes in each foot at an angle as shown in Figure 5-8.
Tripod Installation Manual Models CM110, CM115, CM120 5.5 Tripod Grounding Drive the ground rod close to the center of the tripod using a sledge hammer or fence post driver. Strip 1/2” inch of insulation from both ends of the black 4 AWG ground wire.
Page 17
Tripod Installation Manual Models CM110, CM115, CM120 FIGURE 5-10. Lightning Rod and Tripod Grounding Lug...
Tripod Installation Manual Models CM110, CM115, CM120 5.6 Crossarm Attachment Attach the CM202 (2 ft, 0.6m), CM204 (4 ft, 1.2m), or CM206 (6 ft, 1.8m) crossarm to the tripod mast as shown in Figure 5-11. For wind sensors, the crossarm should be approximately 103 inches above the ground for a 3m mounting height, or 64 inches for a 2m mounting height.
Page 19
Tripod Installation Manual Models CM110, CM115, CM120 FIGURE 5-12. ENC 12/14 Enclosure Attached to the Tripod Base...
Page 20
Tripod Installation Manual Models CM110, CM115, CM120 FIGURE 5-13. ENC 12/14 Enclosure Attached to the Mast...
Tripod Installation Manual Models CM110, CM115, CM120 6.1 CM210 Crossarm Mounting Kit CM2XX crossarms include a CM210 bracket as shown in Figure 6-1. The CM210 can be ordered separately to attach a user-supplied pipe (1.0 – 1.5” OD) to a mast or tower leg (1.0 – 2.1” OD), or to attach a crossarm to two tower legs.
Page 23
Tripod Installation Manual Models CM110, CM115, CM120 6.2 CM215 Mast Mounting Kit The CM215 attaches to the top of the mast, and provides a 3/4” or 1” mounting pipe (1.0” or 1.32” OD) that extends 4” above the mast, as shown in Figure 6-2.
Tripod Installation Manual Models CM110, CM115, CM120 6.4 CM225 Pyranometer Mounting Stand The CM225 mounts a pyranometers (CM3, LI200X, LI190SB, SP-Lite, and Eppley) to a horizontal (1.0 – 2.1” OD) or vertical pipe (1.0 – 2.1” OD) as shown in Figure 6-4.
Tripod Installation Manual Models CM110, CM115, CM120 6.5 CM230 Adjustable Angle Mounting Kit The CM230 mounts an antenna (1.0 – 1.5” OD) to a mast or vertical pipe (1.3 – 2.1” OD) as shown in Figure 6-5. The bracket allows the antenna to be adjusted for different angles.
Tripod Installation Manual Models CM110, CM115, CM120 6.7 RM Young Gill Radiation Shields RM Young Gill Radiation Shields are used to house and attach temperature and relative humidity sensors to the tripod mast (1.0 – 2.1” OD) or crossarm as shown in Figure 6-7.
Appendix A. Tripod Tote Bag The Tripod Tote Bag is an option for the CM1XX tripods. The bag is constructed of nylon, with a main compartment for the tripod base, and pockets for stowing the other components as shown below: Mast(s) Ground Rod Lightning Rod...
Campbell Scientific Companies Campbell Scientific, Inc. (CSI) 815 West 1800 North Logan, Utah 84321 UNITED STATES www.campbellsci.com info@campbellsci.com Campbell Scientific Africa Pty. Ltd. (CSAf) PO Box 2450 Somerset West 7129 SOUTH AFRICA www.csafrica.co.za sales@csafrica.co.za Campbell Scientific Australia Pty. Ltd. (CSA)