Table of Contents
Advertisement
SECTION 5: ASSEMBLY INSTRUCTIONS
IMPORTANT:
After assembly, service engine
with gasoline, and check oil level as instructed in the
separate engine manual packed with your unit.
NOTE:
References to right or left side of the snow
thrower are determined from behind the unit in the
operating position.
UNPACKING
• Remove staples or break glue on the top flaps
of the carton. Remove any loose parts
included with unit.
• Cut along dotted lines and lay end of carton
down flat. Remove packing material.
A
D
F
• Roll
unit
thoroughly for loose parts before discarding.
TOOLS REQUIRED FOR ASSEMBLY
• (1) 3/8" or adjustable wrench
• (2) 7/16" or adjustable wrench
• (2) 1/2" or adjustable wrench
LOOSE PARTS IN CARTON (See Figure 1)
A
(2) Handles (Right and Left)
B
(1) Handle Panel Assembly w/ Light
C
(1) Speed Selector Plate
D
(1) Shift Lever
E
(1) Chute Crank Assembly
E
Figure 1
6
out
of
carton.
Check
B
C
carton
Advertisement
Table of Contents
