Table of Contents
Advertisement
Periodic maintenance and adjustment
1. V-belt wear limit
New V-belt width:
34.1 mm (1.34 in)
V-belt wear limit width:
32.5 mm (1.28 in)
3.
Install the drive guard, and then install the
left side cover and the shroud.
To replace and adjust the V-belt
EWS00411
WARNING
When installing a new V-belt, make sure
that it is positioned properly. Otherwise,
the V-belt clutch engagement speed will
be changed and the snowmobile may
move unexpectedly when the engine is
started, which could cause an accident.
56
1. Edge of the secondary sheave assembly
2. Spacer
3. V-belt position adjusting bolt
ECS00510
NOTICE
As the V-belt wears, adjustment may be
necessary. To ensure proper clutch per-
formance, the V-belt position should be
adjusted by adding a spacer on each ad-
justing bolt when the V-belt position
reaches 1.5 mm (0.06 in) below the edge of
the secondary sheave assembly.
Have a Yamaha dealer make this adjust-
ment.
TIP
Apply the parking brake before replacing the
V-belt.
1.
Remove the shroud and the left side cov-
er, and then remove the drive guard.
(See page 43 for removal procedures.)
Advertisement
Table of Contents
