AEG NSC8M191DS User Manual page 27

Problem
Temperature cannot be set.
The temperature in the appli‐
ance is too low/too high.
appears on the
display.
The symbol ap‐
pears and the alarm indica‐
tor is on.
Possible cause
The Extra Freeze function or
Extra Cool function is switch‐
ed on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are stor‐
ed at the same time.
The door has been opened
often.
The Extra Freeze function is
switched on.
The Extra Cool function is
switched on.
There is no cold air circula‐
tion in the appliance.
The appliance is in the dem‐
onstration mode.
Communication problem.
ENGLISH
Solution
Switch off Extra Freeze func‐
tion or Extra Cool function
manually, or wait until the
function deactivates auto‐
matically to set the tempera‐
ture. Refer to "Extra Freeze
function" or "Extra Cool func‐
tion" section.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces‐
sary.
Refer to "Extra Freeze func‐
tion" section.
Refer to "Extra Cool func‐
tion" section.
Make sure that there is cold
air circulation in the appli‐
ance. Refer to "Hints and
tips" chapter.
To exit the demonstration
mode, press and hold the
Extra Cool and ECO buttons
for approximately 10 sec‐
onds until you hear 3 short
beeps.
Contact the nearest Author‐
ised Service Centre. The
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible.
27