Panasonic Toughbook CF-W8EWAZZJM Operating Instructions Manual page 33

3 Press .
F9
At the confirmation message, select [Yes] and press Enter.
4 Select the [Main] menu, then select [Optical Drive Power] and
5 Select [On] and press
6 Press .
F10
At the confirmation message, select [Yes] and press Enter.
The computer will restart.
7 While [Panasonic] boot screen is displayed, press and hold
appears at the bottom of the display.
When the PC-Diagnostic Utility starts up, it will automatically begin the diagnostic check for all hardware components.
If the password is requested, enter the password.
The touch pad and the internal keyboard cannot be used until alternating blue and yellow colors are displayed
on the left side of the hardware icon (A).
By clicking the icon, you can execute the following operations:
• : Start the diagnostic check from the beginning
• : Stop the diagnostic check (You cannot restart the check partway through by clicking
: Display help (click the screen or press Space to return to the original diagnostic check screen)
•
You can check the status of the diagnostic check by the display color on the left side of the hardware icon (A).
• Aqua: Not running diagnostic check
• Alternating blue and yellow: Currently running diagnostic check. The interval of the alternating colors differs
depending on the type of diagnostic check currently running.
During memory diagnostic check, the display may freeze for a long period of time. Wait until the process is
complete.
• Green: No problems discovered
• Red: Problems discovered
NOTE
Using the following procedure, you can run a diagnostic check on a specified hardware component,
or run an extended diagnostic check on the hard disk, keyboard and touch pad (You do not need to
perform the extended diagnostic check for the keyboard and touch pad in normal use.). The
extended diagnostic check on the hard disk is more detailed, and so requires a longer period of time
to run.
A Click to stop the diagnostic check.
B Click the icon for the hardware that is not to be checked, so that the icon is displayed in gray (B).
When running a check on the hard disk, keyboard or touch pad, clicking the icon once will turn on
the extended diagnostic check ("FULL" (C) will be displayed below the icon); click again, and the
icon will be displayed in gray (D).
C Click to start the diagnostic check.
8 When all the hardware has been checked, confirm the diagnostic check results.
If the display is red and the message "Check Result TEST FAILED" is displayed, you can assume that there is a
problem with the computer's hardware. Confirm which hardware component is displayed as red, and contact your
technical support office.
If the display is green and the message "Check Result TEST PASSED" is displayed, the computer's hardware is
operating normally. Continue using the computer as it is. If the computer still does not operate properly, reinstall
the software. ( page 25)
.
Enter
.
Enter
+ until Please Wait
Ctrl F7 "
A
)
e.g. hard disk
"
B
C
D
33