Panasonic Toughbook CF-T8EWDTZ2M Operating Instructions Manual page 27

p Battery
The battery indicator is
lights red.
The battery indicator is
blinking.
The battery indicator is
flashing.
Touch Pad/Touchscreen
The cursor does not work.
Cannot input using the
touch pad.
Cannot input using the
touchscreen.
Cannot point the correct posi-
tion using the included stylus.
Reference Manual
The Reference Manual is not
displayed.
Others
No response.
The battery level is very low (the charge is approx. 9% or less).
Connect the AC adaptor. You can use the computer when the indicator light is orange. If
you do not have an AC adaptor, save your data and power off your computer. After
replacing the battery pack with a fully charged one, turn your computer on again.
If blinking red:
Quickly save your data and power off your computer. Remove the battery pack and dis-
connect the AC adaptor, then connect them again. If the problem persists, contact your
technical support office. The battery pack or charging circuit may be defective.
If blinking orange:
• Battery cannot be recharged temporarily because the internal temperature of the bat-
tery pack is outside the acceptable temperature range for recharging. Your computer
can be used normally in this state. Once the range requirement is satisfied, charging
begins automatically.
• Software applications and peripheral devices (USB devices, etc.) are consuming too
much power. Exit the software applications currently running, and remove all peripher-
als. Once the range requirement is satisfied, charging begins automatically.
The battery is recharging.
If [Battery Charging Indicator] in [Main] menu of the Setup Utility is set to [Flashing], the
indicator will alternately become lighter and darker.
When using the external mouse, connect it correctly.
Restart the computer by using the keyboard.
U , and R to select [Restart].
Press ,
If the computer does not respond to keyboard commands, read "No response" (
Set [Touch Pad] to [Enabled] in the [Main] menu of the Setup Utility.
The drivers for some mice may disable the touch pad. Check your mouse's operating instructions.
When mouse drivers are installed (i.e. IntelliMouse), the touchscreen does not work.
Reinstall the touchscreen driver.
Set [Touchscreen Mode] to [Auto] or [Touchscreen Mode] in the [Main] menu of the
Setup Utility.
Perform the touchscreen calibration (
Install Adobe Reader.
<For localized OS model>
A Log on to Windows as an administrator.
B Click [start] - [Run] and input "c:\util\reader\setup.exe", then click [OK].
C Follow the on-screen instructions.
<For MUI OS model>
( page 13)
Ctrl + Shift + Esc to open Task Manager and close the software application that
Press
is not responding.
An input screen (e.g., password input screen at startup) may be hidden behind another
Alt + Tab to check.
window. Press
Slide the power switch for four seconds or longer to shut down the computer, and then slide
the power switch to turn it on. If the application program does not work normally, uninstall and
reinstall the program. To uninstall, click [start] - [Control Panel] - [Add or Remove Programs].
page 14).
below).
27