Table of Contents
Advertisement
4 When the message [[Backup] is complete] or [[Restore] is complete] is displayed, press
Ctrl + Alt + Del to restart the computer.
• If the backup or restore process was interrupted before completion, for example if the power
was turned off, execute the process again.
• When a new device is installed and a message appears advising that the computer must be
restarted to enable the settings, select [Yes] to restart the computer.
CAUTION
When the hard disk backup function has been enabled, the backed up data will not be erased
even if a commercial data erasing utility or similar software is used to erase all data from
user-accessible area. You can use the hard disk data erase utility included in this computer
(
page 42) to erase all data on the hard disk, including backed up data. Use this hard disk
data erase utility before disposing of or transferring ownership of this computer.
Occasionally, the message [#1805 cannot write image file] will be displayed, and the backup
function will be interrupted. If this error occurs, execute the backup function again. After
this, if the backup function is completed properly, then there is no problem in the hard disk.
To disable the hard disk backup function
Perform the reinstallation procedure. All data in the backup area and the hard disk will be erased.
Conduct steps 1-8 for [Reinstalling Software] (
reinstallation at the screen for executing the reinstallation.
• When [1] is selected, the hard disk backup function can be disabled.
• When [2] is selected, the hard disk backup function can be disabled, but in this case, because
the hard disk has been divided into partitions, the hard disk backup function cannot be re-
enabled (
page 26).
• When [3] is selected, the hard disk backup function cannot be disabled.
<When the hard disk backup function has been enabled>
If you select [3] in step 9 (
partition (data partition) may be switched with that of the SD memory card. You can still use the
drives after the letters have been switched, but you can also return the drive letters to their original
state using the following procedures.
(The following procedure assumes that before reinstallation, the second partition (data partition)
was Drive D:, and the SD memory card was Drive E:)
1 Disable the drive letter for the second partition (data partition).
1 Click [start] - [Control Panel] - [Performance and Maintenance] - [Administrative Tools] and
double click [Computer Management].
2 Click [Disk Management] from [Storage].
3 Right click on the partition for which [E:] is displayed and click [Change Drive Letter and
Paths...].
4 Click [Remove].
5 At the confirmation message, click [Yes].
2 Change the SD memory card drive letter to [E:].
Use the SD drive letter change tool to change the SD memory card to the E: drive. (
"SD Memory Card/ MultiMedia Card")
3 Set the drive letter for the second partition (data partition) as [D:].
1 Click [start] - [Control Panel] - [Performance and Maintenance] - [Administrative Tools] and
double click [Computer Management].
2 Click [Disk Management] from [Storage].
3 Right click on the partition for which the drive letter is not displayed, and click [Change
Drive Letter and Paths...].
4 Click [Add...], assign [D:] as the drive letter, and click [OK].
page 34). Select [1] or [2] to execute the
page 34) and execute reinstallation, the drive letter for the second
41
Advertisement
Table of Contents
