Advertisement
DEWALT
®
Signal Live Hub - Quick Start Guide
Fixed securely in a raised location where the Hub
●
will not be moved during normal site activities;
6. Remember to switch off the Hub after monitoring the
pour, to conserve battery.
Setup and use
The Hubs assigned to your site can be found on the inventory screen in the app or the ConcreteDNA web
platform (app.concretedna.com).
Each time the Hub is switched on, It will take up to 5 minutes for the LED to start flashing. Once it starts flashing,
the device will enter a setup mode for the first 20 minutes of operation. During this time, the platform will update
more frequently, displaying the sensors in range and their Bluetooth signal strength. This enables you to find an
optimal location where the Hub is both in range of all sensors and with good cellular connectivity.
After setup mode has finished DEWALT® Signal Sensor information will update each time it connects (typically
every 20 minutes).
All sensors in range will have their measurements collected automatically.
Note: if a sensor has not been registered, this will be shown as not registered. You need to register the sensors
first to allow the DEWALT® Signal Live Hub to collect measurements.
Led Patterns
Colour
Cyan > White
White
Amber
Red
Red > Amber > Green
Green
Charging the battery
A DEWALT® Signal Live Hub will charge from empty to full overnight (around 10hrs). Once fully charged the
battery will last up to 6 weeks.
1.
Connect the supplied charger to the DEWALT® Signal Live Hub;
2. The LED will briefly flash to indicate the charger is connected and will stay on showing the current charge
level;
3. If the DEWALT® Signal Live Hub is off while charging, the LED will display the current charge level.
Note: Only charge DEWALT® Signal Live inside, using the supplied charger.
State
Setting up
Active: battery level > 80%
Active: battery level > 30%
Active: No Network Connection or
battery below 30 %
Charging
Green - Firmware updating
Advertisement
