Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for DeWalt DW083-XE
Summary of Contents for DeWalt DW083-XE
- Page 1 INSTRUCTION MANUAL DW083-XE SELF-LEVELING 3 BEAM LASER POINTER...
-
Page 3: Definitions: Safety Guidelines
• Tool service must be performed only by qualified repair personnel. Service or Laser class maintenance performed by unqualified personnel may result in injury. To locate Wavelength 630–680 your nearest DeWALT service center call 1-800-4-DEWALT (1-800-433-9258) or Protection class IP54 go to www.dewalt.com on the Internet. Self-leveling range °... -
Page 4: Laser Information
Laser Information leak, and can cause injury or fire. To The DW083-XE laser level is a class 2 laser product and complies with 21 CFR reduce this risk: 1040.10 and 1040.11 except for deviations pursuant to laser notice No. 50, dated •... -
Page 5: Operating Tips
INTENDED USE a) Have your power tool serviced by a qualified repair person using only This DW083-XE self-leveling 3 beam laser pointer is designed for professional leveling identical replacement parts. This will ensure that the safety of the power tool applications. -
Page 6: Operation
OUT OF TILT RANGE INDICATOR a short time while the batteries continue to drain. After fresh The DW083-XE laser is designed to self-level. If the laser has been tilted so much that batteries are installed and the laser is turned on again, the it cannot level itself (>... -
Page 7: Maintenance
Industrial Tool Co., Stanley Black & Decker, 82 Taryn Drive, Epping, VIC 3076 conduct a calibration check using a distance no shorter Australia, call 1800 444 224 or (NZ). 0800 339 258 or visit our website: www.dewalt. than the distance of the applications for which the tool com.au or www.dewalt.co.nz. -
Page 8: Troubleshooting
2. Mark the beam position on the first THE LASER BEAMS FLASH wall. The DW083-XE laser level has been designed to self-level up to 4° in all directions 3. Turn the unit 180˚, and mark the beam FIG. 9 when positioned as shown in Figure 4. If the laser is tilted so much that internal position on the second wall (Fig. -
Page 9: Specifications
SPECIFICATIONS Light Source Semiconductor laser diode Laser Wavelength 630–680 nm Visible Laser Power <1mw (each beam) CLASS 2 LASER PRODUCT Working Range 30 m (±100') Accuracy* (Up) ±6 mm @ 30 m (± 1/4" @ 100') Accuracy* (Level) ±6 mm @ 30 m (± 1/4" @ 100') Indicators Flashing Indicator: battery low Flashing Laser: tilt range exceeded... - Page 12 Stanley Black & Decker 82 Taryn Drive, Epping, VIC 3076 Australia • 1800 444 224 (Aust) or 0800 339 258 (NZ) www.dewalt.com.au • www.dewalt.co.nz (MAY12) Part No.N166261 DW083-XE Copyright © 2012 D WALT The following are trademarks for one or more D WALT power tools: the yellow and black color scheme;...