Fisher & Paykel WODV2-30 N Care & Cleaning page 3

1. Hold the door firmly in an approximately halfway
open position.
3. Open the door completely and check that the
hinges are both secured by the correct notches as
shown.
4. Rotate the locks into the closed position.
Removing & Replacing the Sliding Shelves & Sides Racks
1. To remove a sliding shelf, grip it by its two front corners (making sure you are gripping the wire shelf and the
sliding frame together), tilt upwards and pull it out of the oven.
2. To remove the side racks, gently push the retaining wire from underneath the lock stud, then swing the lowest
edge of the side rack up and out towards the center of the oven until the rack is almost horizontal. The prongs
at the top will slide out of the mounting slots.
3. To replace the side racks, hold them almost horizontally and locate the rpongs into the small mounting slots at
the top of the oven cavity. While you are doing this, support the rack with your hand from underneath, to
ensure that both prongs perfectly locate into the mounting slots.
https://producthelp.fisherpaykel.com/us/Cook/Built-In_Ovens/Double/WODV2-30_N/User_Guide_WODV2-30_N/09_Care_an...
2. Align the hinge tongue with the hinge slots and
push the door until you feel the latches locate into
position on each side.
4. Close the oven door.
Hinge locks should rest
inside the slots. Incorrect
installation will prevent door
from correctly sealing..
Updated: Sun, 09 Apr 2023 08:10:54 GMT
Powered by
3