Xingyun XY-E Instruction Book

Counting operation requires the weight of weighed thing must heavier than the four
times of minimum reading value or the difference of counting could be great if not
counting can't be done.
(2) Quit the counting operation:
Press the "Mode" button and then "= = = = = =" will be displayed. The scale may quit
counting operation state immediately and return the weighing state.
(3) Overload warning
When weighing thing is over the maximum weighing value of the scale, the display will
show "- - - - - -" and indicate the thing is overloaded. The weighing thing shall be removed
to avoid damaging the scale.
IX Cautions
(1) Switch on power resource according to requirements to make scale warm up before
usage.
(2) Working environment and conditions shall conform to the environment requirements.
(3) The weight of all weighing things on the weighing tray can't exceed the required
weighing range.
(4) When weighing is not accurate, calibration shall be undertaken by use of standard
weight according to concerning requirements.
(5) If user found any defection in the scale, don't try to disassemble the machine shell and
repair it to avoid damaging the precision parts in the machine. Please take it to the
distributor or send it to the manufacturer and let them repair.
X Minimum weight choose
Press "COU" and Power on at the same time, when it show "1d" and you can press" COU"
to choose the 1d to 5d( the d means resolution)
XI Indicator light
If display show "ＦＵＬＬ",it means the battery full, so please stop in charge.
If display show "LO-BAT" means low battery , so please in charge.
If display show "LO-BAT"+ alarm voice means the battery will finish.
XII Baud rate
Press "TARE" and power on, it will show the baud rate, then press "COU" to confirm.
XIII Package list
Electronic scale 1 set Instruction book
Weighing tray 1 Electrical wire
1 copy
1
WEIGHING SCALE
INSTRUCTION BOOK
(XY)