Xingyun XY-2C User Manual

Package list
Ⅸ
Electronic balance 1 set
Weighing tray 1 Power adapter
Ⅹ Tare
(1) If there is a container on the weighing tray, the balance displays the weight of
container.
(2) Press "TARE" and then "0.00" will be displayed. It indicates that the tare has been
deducted.
(3) Place the thing into container and the balance will display the weight of thing.
Ⅺ The counting operation of balance
(1) Press "COU" button and "COU" will be displayed. Then display blinkingly one of value
of counting mode, "5,10,20, 40, 50, 100, 200, 300, 400, 500" Press "TARE" and choose
one mode value. Place the things with same quantity with mode value on the weighing
tray and then press "confirm" button". Then "= = = = = =" will be displayed. Very sonly ,
it will display stable mode value and then the setting of counting
finished. After that, counting operation could be conducted.
Place the things in the weighing tray and display will show
the quantity of thing.
Counting operation requires the weight of weighed thing must heavier than the four
times of minimum reading value or the difference of counting could be great if not
counting can't be done.
(2) Quit the counting operation:
Press the "COU" button and then "= = = = = =" will be displayed. The balance may quit
counting operation state immediately and return the weighing state.
(3) Overload warning
When weighing thing is over the maximum weighing value of the balance, the display
will show "- - - - - -" and indicate the thing is overloaded. The weighing thing shall be
removed to avoid damaging the balance.
Ⅻ Cautions
(1) Power on resource according to requirements to make balance warm up before usage.
(2) Working environment and conditions shall conform to the environment requirements.
(3) The weight of all things on the weighing tray can't exceed the required weighing range.
Instruction book 1 copy
1
operation is
USER MANUAL