JVC HR-J267MS Instructions Manual page 7

M ajor Countries
Australia, New Zealand, Kuwait, U.A.E.,
Indonesia, Singapore, Thailand, Malaysia,
Iran, Saudi Arabia, Egypt, Morocco,
Lebanon, Iraq
China, Mongolia, Russia
Hong Kong
O K
D O N O T press any button on the recorder or remote control while Auto Set U p is in progress.
D uring Auto Set U p
"PLEASE WAIT" blinks on the screen and "Auto"
blinks on the front display panel.
N O TES:
● If you perform Auto Set Up when the aerial cable is not connected properly, "SCAN COMPLETED -NO SIGNAL-" appears on
the screen. When this happens, make sure of the aerial connection and press O K ; Auto Set Up will take place again.
● If there is a power cut, or if you press
turn off the recorder power once and try again.
● If you want to set the tuner manually such as to add or skip channels, to swap channel positions, or to fine-tune channels,
pg. 29–31.
● If no sound accompanies the picture or the audio sounds unnatural on some channels that have been stored by Auto Set Up,
the TV system setting for those channels may be incorrect. Select the appropriate TV system for those channels.
Selection – When you see the picture but the audio can't be heard or sounds unnatural" on page 31.
Downloaded from: https://www.usersmanualguide.com/
0
4
2
PU SH JO G
3
AUTO CH SET
PLEASE WAIT
START FINISH
or M EN U while Auto Set Up is in progress, Auto Set Up will be interrupted; be sure to
TV System
5
B/G
D/K
I
6
When Auto Set Up is completed, the lowest position
number will appear on the front display panel.
SELECT TV SYSTEM
Press PU SH JO G %fi to place the pointer next to the
appropriate TV system (refer to the table on the left).
ST ART AUTO CHAN N EL
SET
Press O K or PU SH JO G .
● The Auto Set Up function scans all the channels that
are receivable by your recorder. It then automatically
assigns each receivable channels to the TV PRO G
buttons. It skips non-receivable channels.
● As Auto Set Up progresses, the "
screen moves from left to right. (See below.)
TV Screen
7
EN
" mark on the
"TV System