Advertisement
All Non-Thermostat Model Heaters 1000W – 4000W
Connect Brown wire – Terminal L.
Connect Blue wire – Terminal N.
Connect Green / Yellow wire - Terminal E
Ensure you correctly tighten the cable gland before securing the terminal
box cover using the four screws.
4.2 400V THREE PHASE.
Please make sure you have read the Safety instructions and that you are
a suitably qualified electrician before continuing.
Pictures show connections inside the terminal box on the heater.
use power tools to undo or do up terminal screws or the enclosure screws.
Please Note:- Specified cable sizes are for typical installations, correction
factors may need to be used when determining actual cable sizes.
Connect Brown wire (Phase 1) – Terminal L1.
Connect Grey wire (Phase 2) – Terminal L2.
Connect Black wire (Phase 3) – Terminal L3.
Connect Blue wire – Terminal N.
Connect Green / Yellow wire - Terminal E
Ensure you correctly tighten the cable gland before securing the
terminal box cover using the four screws.
5. M A INT ENANC E
BN Thermic electric heaters are factory assembled and tested and
are non-user serviceable. they are intended to operate for many
years problem free.
Maintenance is limited to periodic cleaning to ensure there is no
build-up of dust. Before cleaning ensure the supply to the heater is
completely isolated and the heater has cooled down
If in any doubt always consult a qualified electrician for advice.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without
prior notice.
This product conforms to EU Directive 2012/19/EU.
This appliance bears the symbol of the crossed waste bin. This indicates that, at the end of its useful life, it must not be disposed of as
domestic waste, but must be taken to a collection centre for waste electrical and electronic equipment. It is the user's responsibility to
dispose of this appliance through the appropriate channels. Failure to do so may incur penalties established by laws governing waste
disposal.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Your BN Thermic product is guaranteed for one year from date of purchase. We will
repair or replace at our discretion any part found to be defective. We cannot assume any consequential
liability. This guarantee in no way prejudices your rights under common law and is offered as an
addition to consumer liability rights.
REGISTER: Activate your warranty by registering online at www.bnthermic.co.uk and retain this
installation data for future reference.
Do NOT
Use minimum 1mm² 5 Core Cable for
1000W, 1500W and 2000W heaters (see
note above).
Use minimum 1.5mm² 5 Core Cable for
3000W and 4000W heaters (see note
above).
Move two of the push on connections from
the right terminal block over to the empty
connections as per picture to the left.
DO NOT MOVE THE TWO NEUTRAL
CONNECTIONS WHICH ARE TO THE
LEFT END OF THE TERMINAL BLOCK.
BN Thermic Ltd,
34 Stephenson Way,
Crawley, RH10 1TN
Tel: 01293 547361
Email: sales@bnthermic.co.uk
Web: www.bnthermic.co.uk
SWDINS-v01
Advertisement
