Internal Antenna; Removing The Antenna Module (Black Cable) - Dell OptiPlex Micro Plus 7010 Owner's Manual

9. Install the coin-cell battery.
10. Install the side cover.
11. Follow the procedure in

Internal antenna

Removing the antenna module (black cable)

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the M.2 2230 solid-state drive
4. Remove the wireless card.
5. Remove the speaker.
6. Remove the fan.
7. Remove the heat sink.
8. Remove the optional I/O module (VGA/HDMI/DP/Serial)
9. Remove the system board
NOTE: The system board can be removed with the memory, coin-cell battery, and processor attached
.
About this task
The following image(s) indicate the location of the antenna module (black cable) and provides a visual representation of the
removal procedure.
Steps
1. Remove the antenna cable from the routing guides on the chassis.
2. Loosen the captive screw that secures the antenna module (while cable) to the chassis.
3. Lift the antenna module (black cable) from the chassis.
After working inside your
Before working inside your
or M.2 2280 solid-state
computer.
computer.
drive, whichever applicable.
or the optional Type-C
Removing and installing Field Replaceable Units (FRUs)
module, whichever applicable.
71