Table of Contents
Advertisement
WARNING
Disconnect the electrical supply before servicing or cleaning the unit. Failure to do
so could result in electrical shock or personal injury from cleaner suddenly
starting.
Three Screws
Trois vis
Tres tornillos
Lower Plate
Plaque inférieure
Base inferior
Motor Drive
Shaft
Arbre du moteur
Eje del motor
Belt
Courroie
Correa
Electrical Shock or Personal Injury Hazard
Removing and Installing Lower Plate
Replacing Belt
Agitator
Agitateur
Agitador
Before servicing any parts,
disconnect vacuum from electrical
outlet.
Place paper under nozzle anytime
lower plate is removed to protect
floor.
Place handle in down position and
turn vacuum over to expose lower
plate.
Release lower plate by removing
three (3) screws.
Remove lower plate and remove any
residue that may exist in belt area.
Reinstall lower plate by hooking
front end of lower plate into slots on
front of nozzle housing.
Make sure all wires are routed
properly and not pinched.
Press lower plate into place then
replace three (3) screws.
Remove lower plate.
Remove agitator by carefully lifting
out.
- 24 -
Advertisement
Table of Contents
