Table of Contents
Advertisement
Lift Agitator Up
Soulever l'agitateur
Unidad del agitador
Motor Shaft
Arbre d'entraînement
du moteur
Eje del motor
End Cap
Bouchon
Tapa del
extremo
Replacing Belt
+
+
Install
New Belt
Poser la
nouvelle
courroie
Instalación
de la correa
+
Groove
Ouverture
Ranura
Remove lower plate.
Remove agitator by carefully lifting
out.
Remove worn or broken belt.
If end caps fall off, do not lose the
two (2) washers.
Clean agitator and replace the two (2)
washers and end caps.
Loop new belt (Panasonic Type UB8
only) around motor shaft and brush
pulley; see illustration for correct
belt routing.
Reinstall agitator back into nozzle
housing grooves.
After reinstalling the agitator, turn it
by hand to make sure that belt is not
twisted or pinched and that all
rotating parts turn freely.
Reinstall lower plate.
- 26 -
Advertisement
Table of Contents
