Complete The Installation - Kohler K-12100 Installation Manual

Flush Installation
(Top Down View)
2x4 Studs
Water-Resistant
Wall Material
1/4" (6mm) Gap

7. Complete the Installation

Flush Installations
Install water-resistant wall material to within 1/4" (6 mm) of the module edge.
Install desired trim (not provided) around the unit to conceal the module edge.
Also install trim along the bottom apron edge.
Alcove Installations
Install water-resistant wall material around the unit to conceal the module edge.
All Installations
Apply a bead of silicone sealant to the nailing-in flanges.
Install water-resistant wall material with the paperbound edge a maximum of 1/4" (6 mm) above
the finished, concave surface of the module.
Tape and mud the wall material.
Seal around the valving and outlets with silicone sealant or plumbers putty.
Install the faucet and drain trim according to the faucet manufacturer's instructions.
If applicable, install the grab bars and towel bars. Refer to the accessory manufacturer's instructions
to properly secure the accessory to the wall surround.
If applicable, install the shower door according to the manufacturer's instructions. Only apply
sealant where instructed to do so.
Clean up with a non-abrasive cleaner.
1030529-2-B
1x2 Brace
Module
Trim
Alcove Installation
(Top Down View)
2x4 Studs
Water-Resistant
Wall Material
12
1x2 Brace
Module
1/4" (6mm)
Gap
Kohler Co.