Advertisement
Steps (continued):
3. Remove the terminator from the SeaTalk
can be extended.
4. Install the terminator that was removed from the 'Tee' connector on one of the blue ports of
the SeaTalk1 to SeaTalk
5. Connect one end of a new SeaTalk
terminator was removed) and the other end to the other blue port on the SeaTalk1 to
ng
SeaTalk
converter.
6. Terminate the wires of the SeaTalk cable in the AP-WRC4 terminals as follows:
7. Plug the yellow connector of the SeaTalk cable into the yellow port of the SeaTalk to
ng
SeaTalk
converter.
8. Turn on the EV-100 and the 12V supply cable which supplies the SeaTalk
9. Check the green light on the SeaTalk1 to SeaTalk
10. Turn on the AP-WRC4 using the rocker switch at the bottom of the base unit.
11. Check that the blue 'OP' LED on the AP-WRC4 flashes 3 times after being turned on.
12. Check the orange 'ST' LED is off and remains off after 5 seconds. If the 'ST' LED turns on, wait
for several more seconds and verify that it eventually turns off.
13. To finish off, mount the AP-WRC4 base unit and SeaTalk to SeaTalk
accordance with their respective manuals and tidy up the cabling. The AP-WRC4 User
Manual is available from the 'Downloads' page at https://www.madmanmarine.com
Terminator
5-way Connector
*Blanking Plug
*Terminator
Items marked with * are part of Raymarine SeaTalk
AP-WRC4 Installation
EV-100 Evolution Autopilot
ng
backbone 'Tee' connector so that the backbone
ng
converter. Refer to Figure 3 for this and subsequent connections.
ng
backbone cable to the 'Tee' connector (where the
Wire
Function
Red
+12V
Yellow
SeaTalk
Screen/Shield
0V
Backbone
ng
SeaTalk
to SeaTalk1
converter
Figure 3 - AP-WRC4 Installation
www.madmanmarine.com
With
Terminal Symbol
SeaTalk
Screen
ng
is on (and flashing periodically).
ng
New SeaTalk
Backbone Cable
*SeaTalk1 Cable
*Blanking Plug
ng
to SeaTalk1 Converter Kit Part No. E22158
ng
backbone.
Converter in
Terminator
Removed
ng
Advertisement
