Power Supply Installation - Toro EVOLUTION Series Quick Start Manual

Set the Beginning of the Week
Step 1 – Use the Down
Step 2 – Use the Up or Down
Press SELECT
Step 3 – Navigate to the next item or press the
Installation

Power Supply Installation

WARNING: AC power wiring must be installed and connected by qualified personnel only. All electrical components and installation procedures must
comply with all applicable local and national electrical codes. Some codes may require a means of disconnecting from the AC power source installed in
the fixed wiring and having a contact separation of at least 0.120" (3mm) in the line and neutral poles. Make sure the power source is OFF prior to connecting
the controller. If the supply cord is damaged, it must be replaced by the manufacturer. its service agent or a similarly qualified person in order to avoid a hazard.
WARNING: This appliance is not intended for use by persons (including children) with reduced physical sensory, or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their
safety. Children should be supervised to ensure that they do not play with the appliance.
Indoor and 240 VAC Outdoor Models
Indoor models and the 240 VAC Outdoor model will be pre wired with a power cord ready to be plugged into
a wall power socket ( Figure 6 ).
110 VAC (US and Canada) Outdoor Models
Step 1 – Route power and ground wires from a power source through a conduit and into the
EVOLUTION cabinet.
®
Step 2 – Open the EVOLUTION
Step 3 – Remove the power compartment cover to access the transformer wiring.
Remove 1/2" (12.7mm) of insulation from the wire ends.
Step 4 – Using the provided wire nuts, secure the transformer Line (black) wire
to the black power source wire, Neutral (white) to the white power source wire and Equipment
Ground wire (green) to the green power source wire.
Note: Earlier EVOLUTION
Connect both wires to the green power source wire.
Step 5 – Install and secure the power compartment cover.
Step 6 – Apply power to the controller.
arrow to select BEGIN WEEK. Press the Right
arrows to select SUNDAY (default) or MONDAY as the beginning of the weekly schedule.
when finished.
HOME button to return to the main screen if setup is complete.
controller and access the internal components.
®
model is equipped with two Equipment Ground wires (green).
®
arrow or SELECT .
Figure 6
Figure 7
Black White Green
110 VAC Outdoor Models
9