Table of Contents
Advertisement
Available languages
Available languages
Installation
CONNECTING STRING LIGHTS
Connecting Sets End to-End.
When multiple products are connected together, do not exceed the lowest indicated maximum wattage on the cord tag near the connected product's receptacle
Connect to
Power Outlet
IMPORTANT: SCREW IN BULBS TIGHTLY. PLUG IN SET.
TIGHTEN ANY BULBS THAT DO NOT LIGHT.
INSTALLATION METHODS
1
Using a guide wire with S-hooks or temporary ties (not included)
Attach guide wire to
structural support
2
Attached to a structure
Structural
Support
Screw
hook
CONNECTING MULTIPLE SETS
USING INCLUDED LED BULBS
MAXIMUM WATTAGE
1 WATT
WHEN USING
1 WATT (included)
5 WATTS
7.5 WATTS
10 WATTS
15 WATTS
CAUTION:
756 WATTS WHEN USING OTHER
WATTAGE LED BULBS
The performance specifications (life hours) printed on this manual should
only be considered an approximation of expected performance.
String Light
24 ft
Guide Wire
(not included)
Attach to structural support
Recommended 12 ft.
NUMBER OF STRING LIGHTS
60 SETS
NUMBER OF STRING LIGHTS
60 SETS
12 SETS
8 SETS
6 SETS
4 SETS
DO NOT EXCEED
female cap
S-hooks or temporary
ties (not included)
Attach to structural support
Recommended 12 ft.
Structural
Support
Screw
hook
TROUBLESHOOTING
1. Confirm power is turned on.
2. Before performing any troubleshooting, make sure to unplug string light completely from power supply.
3. If one or several bulbs do not light, gently grasp and tighten bulbs further into socket. Do not over
tighten. Plug into power supply and retry.
4. If none of the bulbs light up, check the fuse at end of cord. This product employs overload protection
(fuse). A blown fuse indicates an overload or short-circuit situation. If the fuse is blown, unplug the
product from the outlet. Also unplug any additional strings or products attached to the product.
Replace the fuse as per the instructions below (follow product marking for proper fuse rating) and
check the product. If the replacement fuse blows again, it is possible that
a short circuit has occurred and the product needs to be discarded.
TO REPLACE THE FUSE: Grasp plug and remove from the receptacle or
other outlet device. Do not unplug by pulling on cord. Open access cover
on top of the attachment plug. Slide the fuse cover towards the electrical
prongs. Carefully pop out the fuse using a small flat head screwdriver to
remove the fuse (see Image 1). Insert the new fuse (extra provided with
product) and ensure it is properly seated in the plug. To reduce the risk of
fire, replace fuse with only a 7A 125V fuse (extra provided with product).
To close after inserting a new fuse, slide fuse cover back to original position.
Close fuse access cover on top of the attachment plug.
5. Please contact our customer service department should you need
further assistance.
4
Additional String Light
24 ft
TIGHTLY CLOSE FEMALE CAP
WHEN NOT IN USE.
Attach guide wire to
structural support
Screw
.
Structural
Support
hook
DRAWINGS NOT TO SCALE
Image 1
Advertisement
Table of Contents
