JVC HR-J765EK Instructions Manual page 27

Auto SP → LP Timer
If, when timer-recording in SP mode, there is not enough tape to
record the entire programme, the recorder automatically
switches to LP mode to allow complete recording.
For Example . . .
Recording a programme of 210 minutes in length onto a 180-
minute tape
Approximately 150 minutes
SP mode
Make sure you set "AUTO SP → LP TIMER" to "ON" at the Mode
Set screen before the timer-recording starts.
A CCESS MA IN MEN U
SCREEN
1
Press M EN U .
ACCESS MO DE SET
SCREEN
2
Press %fi to move the highlight bar (pointer) to "MODE
SET", then press O K or
SELECT MO DE
3
Press %fi to move the
highlight bar (pointer) to
"AUTO SP → LP TIMER",
then press O K or
select "ON".
RETURN TO N O RMAL
SCREEN
4
Press M EN U .
N O TES:
The Auto SP → LP Timer feature is not available during ITR
(Instant Timer Recording), and the feature will not work
properly with any tapes longer than E-180 or with some tapes
of shorter lengths.
If you have programmed the recorder to timer-record 2 or more
programmes, the second programme and those thereafter may
not fit on the tape if you set "AUTO SP → LP TIMER" to "ON". In
this case, make sure the mode is not engaged, then set the tape
speed manually during timer programming.
In order to ensure that the recording fits on the tape, this
feature may leave a short non-recorded section at the end of
the tape.
There may be some picture noise and sound disturbance at
the point on the tape where the recorder switches from SP to
LP mode.
If you perform timer recording with both PDC and the Auto
SP → LP Timer activated, and the programme goes beyond its
originally scheduled length, there may be times when the
programme cannot be recorded in its entirety.
Downloaded from: https://www.usersmanualguide.com/
Approximately 60 minutes
LP mode
Total 210 minutes
# .
MODE SET
B. E. S. T.
PICTURE CONTROL
# to
AUTO TIMER
O. S. D.
AUTO SP=LP TIMER
[5∞] =
[MENU] : EXIT
Auto Timer
When the Auto Timer is set to ON the timer is automatically
engaged when the recorder power is turned off and automati-
cally disengaged when the recorder is powered back on.
A CCESS MA IN MEN U
SCREEN
1
Press M EN U .
ACCESS MODE SET SCREEN
2
Press %fi to move the
highlight bar (pointer) to
"MODE SET", then press
O K or # .
SELECT MO DE
3
Press O K or
either "ON" or "OFF".
ON
AUTO
OFF
ON
RETURN TO N O RMAL
ON
SCREEN
4
Press M EN U .
N O TE:
For safety, when Auto timer is set to "OFF", all other recorder
functions are disabled while the Timer mode is engaged. To
disengage the timer, press
MAIN MENU
MODE SET
AUTO CH SET
MANUAL CH SET
INITIAL SET
[5 ∞ ] =
[MENU] : EXIT
# to select
MODE SET
B. E. S. T.
PICTURE CONTROL
AUTO TIMER
O. S. D.
AUTO SP=LP TIMER
[5∞] =
[MENU] : EXIT
( TIM ER ).
27
ON
AUTO
OFF
ON
ON