CONTENT: 1. Available modifications. 2. Assembly 3. Installation 4. How to select the cylinder for Eurolock EHT net correctly 5. Introduction 6. Specification 7. Operation and programming in the office mode 8. Operation and programming in the hotel mode 9. The MODE Button 10.
To select a cylinder of a necessary length (L) in dependence of your leaf thickness (Т) use the table. Leaf pattern Cylinder pattern Leaf thickness Cylinder length T (mm) L (mm) www.ironlogic.me Page 5...
16 seconds after the last contact with the card reader; it will notify you with a series of five short sound signals and a flashing red LED. www.ironlogic.me Page 6...
Page 8
Accept mode. In order to exit this mode, bring the master card to the reader; the exit from the mode is indicated by a series of short signals. * In the event of power loss, a previously set Accept mode is maintained even after power is restored. www.ironlogic.me Page 7...
- List of doors that can be opened A detailed set of instructions on setting/operation in the HOTEL mode and a list of specialized software compatible with locks in the HOTEL mode can be found at the manufacturer’s website www.ironlogic.ru. www.ironlogic.me...
- As part of a WiFi* network, with software - Reader bundled with the lock control, connected to the controller using Dallas Touch Memory or Wiegand 26* Available upgrades are on the website www.ironlogic.ru 11. BATTERIES When using alcaline batteries with capacity over 1500 mAh, the lock will operate through no less than 20,000 openings or about 2 years in the standby mode.
Eurolock EHT locks may be connected into a network using RS-485 interface and operate under control from a computer. Specialized software (see www.ironlogic.ru) allows program- ming the locks, controlling their operation and downloading events. However, decisions regarding granting card/key ac- cess are made by the lock itself, regardless of whether it is connected to a PC or not.
- evidence of effect of water and aggressive chemicals. - evidence of unauthorized interference with the circuits. During the warranty period, the Manufacturer shall remedy all failures arising through his fault free of charge. All repairs are performed at the Manufacturer's workshop. Saledate: (L.S.) Signature: www.ironlogic.me Page 11...
Need help?
Do you have a question about the EuroLock EHTnet 72 and is the answer not in the manual?
Questions and answers