Table of Contents
Advertisement
4 Installation Instructions
1.
Mount the Power Center™ Core Hub on the
wall using the 4 mounting screw holes on the
top and bottom flanges. (Mounting hardware
not included).
2.
Using the conduit plan in section 2.2, drill the
knockout holes required for the conduit runs
on the bottom face of the enclosure.
Constrain the drill area as shown.
3.
Route all conduit as cabling as required.
Conduit must comply with UL514B.
CAUTION! All knockout holes must be sealed
to maintain the Type 3R environmental rating
of the enclosure after the installation is
complete.
CAUTION! The restricted knockout area is near the Hub circuitry, so extra care must be taken to avoid
internal components when the knockout holes are being drilled.
CAUTION! Ensure that the enclosure door is properly seated such that the gasket becomes compressed
when the door is securely closed.
5 Electrical Wiring Instructions
IMPORTANT! Wiring methods must be in accordance with local electrical codes. The installer is responsible
for ensuring that over-current protection is installed and sized appropriately for the AC circuits, in
accordance with the National Electrical Code, ANSI/NFPA 70, Canadian Electrical Code and local codes
The patch cables provided in section 4.1 and 4.2 below have pre-assembled connectors at both ends.
strongly recommended that these cables are pulled in conduit prior to the power cables.
CAUTION! Do not install cables if any wires appear damaged or are not terminated improperly. Contact
your Duracell distributor for support.
5.1 EMC to PCS Cable
1.
Terminate the EMC CAT 5 patch cable from the EMS IN
port of the PCS to ethernet port 3 of the EMC.
Note: If a longer extension is required, shielded CAT 5/6
cable must be used.
Restricted knockout area:
1.0
8" W x 5" H
Figure 9: Recommended knock-out area.
Figure 10: EMC cable connection to RJ-45 port.
1.0"
Knockout area:
6" W x 5" H
1.0"
1.0"
It is
10
Advertisement
Table of Contents
