Jiecang JCC50STEW User Manual

JCC50STEW
Curtain Motor
User Manual
01 Product Info
12 14 W
Torque: 1.2 N.m Speed：14cm/s Built-in Wi-Fi module
02 Installation
Removing operation is the same as the installation
03 Caution!
1.This product is for indoor use only, do not use outdoor or in humid environments.
2.The motor will response in operation, please do not proceed to the next step until it
complete.
3.During operation, the effective interval of the transmitter button operation is 10 seconds If
there is no effective transmitter operation for more than 10 seconds, it will automatically exit
the current mode.
4.The motor can be paired with max 10 controllers.
5.The open&close limits cannot be set at the same point. Limits saved even power off.
6.The motor runs constantly for at 6 min max without any other operation.
7.With soft start&stop function,the motor will start and stop slower to make it run elegantly.
8.Do not lift the motor by grabbing the wire or antenna.
04 Instructions
Jogging
Time
Control the OPEN/
STOP/CLOSE of the
Shade
Open &
Close *1
Open & Entering Wi-Fi connection
Wi-Fi connecting
Close *2
mode
Open &
Close *3
Open &
Close *4
a.Pairing Motor with Controller
Way 1:Before adding a new controller
Way 2:After motor is powered on for more than 10s
Note: Pairing can not be done under group channel or 0 channel.
b.Direction Reverse
c.Automatic Open & close Limits Setting
Run to open
limit
automatically
d.Deleting Open & Close Limits
e.Setting and Cancelling Favorite Position
f.Hot key to the Fav. Position
g.Adjusting Motor Speed
Note: If motor doesn't response, the max/min speed has already been reached.
There are 3 speeds adjustable.
h.Removing Controllers
Remove a single controller
Remove controller B via pre-existing controller A
Controller B removed