Subscribe to Our Youtube Channel
Related Manuals for Illuminated Mirrors Diamond X Large
Summary of Contents for Illuminated Mirrors Diamond X Large
- Page 1 Mirrors Illuminated The UK’s Largest LED Mirror Supplier to Trade and Retail Large & Aura Installation Mirrors & User Guide www.illuminated-mirrors.uk.com...
- Page 2 Large Bathroom Mirrors and Aura Range Installation & User Guide Illuminated Infrared Shaver socket IP44 Thank you for purchasing our illuminated mirror(s). To avoid product damage or personal injuries, carefully read, understand, and follow all the Instructions in this installation guide before installing the product.
- Page 3 WARNING! To avoid the risk of electrocution, please turn o the electricity supply mains before commencing the installation. Large & Aura Range of Bathroom Mirrors Instruction manual...
-
Page 4: Table Of Contents
CONTENT IMPORTANT INFORMATION Installation Positioning Installation Operation On/O Infrared Sensor Shaver Socket Ambient Lighting RGB Colour Change Lighting Bluetooth Audio FAQs Large & Aura Range of Bathroom Mirrors Instruction manual... - Page 5 IMPORTANT INFORMATION This product should only be installed by a fully quali ed electrician in accordance with the current IEE wiring regulations (UK) or the equivalent national wiring regulation outside of the UK. This light tting is a Class I product and therefore must be earthed.
-
Page 6: Installation
INSTALLATION 2. Carefully unpack the mirror and lay it on a clean at protected surface. Unscrew the electrical components housing box (a) to reveal the terminal block (b). The size and position of the back box will vary dependent on the model you have purchased. - Page 7 With at least 15cm between the proximity sensor and the nearest surface (c), decide on the location of the mirror and using a level mark the hole locations on the wall (d). F r e e z o n 1 5 c 1 5 c 1 5 c Using an appropriate drill bit for your wall, drill the four mounting...
- Page 8 Pull the power cord through the rubber entry grommet on the side of the electrical components housing box and connect to the terminal block. L i v e E a r u r a N a t Reattach the housing box. And carefully hang the mirror on the four protruding mounting screws.
-
Page 9: On/O Infrared Sensor
Operating Instructions: 1. On/O Infrared Sensor All our Mirrors include an infrared on/o Sensor located on the bottom of the frame, simply wave your hand across the sensor and it will instantly power up the lights and demister pad. Repeat the action to turn the light and demister pad o . - Page 10 5. RGB Colour Change Lighting Simply point you remote towards the small black sensor located on either the bottom or side of the mirror frame. Select you Static Colour option from the keypad. The brightness of the light can be adjusted in steps by pressing the top left two UP and DOWN control buttons.
- Page 11 FAQs 1. What is a LED Mirror? A LED Mirror uses Energy Saving LED light bulbs. They are Waterproof Rated IP44 for use in bathrooms and include clever technology like, Infra-Red on/o sensors, Anti-Mist demister pads and a shaver socket. 2.
- Page 12 5. How do I activate the demister pad? The demister pad works automatically when the lights are turned on and o . 6. Is the mirror tinted glass? No, the mirror is perfectly clear re ective mirror glass. 7. Is the mirror CE & ROHS certi ed? Yes! Large &...
Need help?
Do you have a question about the Diamond X Large and is the answer not in the manual?
Questions and answers