How To Operate; User Directions; User Instruktions; Tips Fot Use - Cissell CF 19 Manual

Hand foot operated utility press
Hide thumbs Also See for CF 19:
Table of Contents

Advertisement

7 How to operate

7.1

User directions

!
Use the press only for the treatment of clothes.
!
Maintenance and repair activities are to be executed by a qualified serviceman.
Not following the instructions of this manual may lead to injury or to damage to the machine!
Caution: After a while, the head (3) will get warm. The downside of the buck (4) and the
steam connections at the backside of the machine are hot. Do not touch these!
7.2
User instructions:
• Pressing.
The press is closed by pressing down the handbar (2) on the head (3). Pressure is obtain by
pressing down the footpedal (7). This footpedal is secured by a latch lever, witch keeps up the
pressure when releasing the pedal. The pedal plate is moveble. The locking mechanism is
released by pressing the frontside of the pedal slightly and the press will open.
• Head Steam.
By operating the valve (1) on the head, headsteam will be released.
• Buck Steam.
By operating the right footpedal (5), bucksteam will be released
• Buck Steam.
By operating the left footpedal (6), the vakuum valve is opened, so that the buch (4) can be
sucked off.
• Head Adjusting (code .../93).
If eventually through wear away of the padding the machine does not press well, you have to
adjust the head. This can be done by turning the adjusting bolts (8) on top of the head.
Adjustment of the latch lever, witch keeps the footpedal down, can be done, if necessary, by turning
the jam net and the set bolt (9) on the frontside of the frontplate.
7.3
Tips for use:
• Only press garments when they are damp.
• Short pressing duration for synthetic fibres, longer duration for cotton/linen.
• Advice: Take care for a maximum temperature of 35ºC on the operators position at an ambient
temperature of 25ºC and an relatively humdidity of 65%.
• Take care for sufficient ventilation.
• Take care for sufficient light on the workshop.
8

Put out of operation

• Remove vacuum.
• Close the steam shut off valve (W, see figure 1).
• Blow of steam by opening the blow off cock (Y).
Cool down the machine.
English - 7

Advertisement

Table of Contents
loading

Table of Contents