Table of Contents
Advertisement
Step 2
Lift and pull the latches until they click.
Step 3
Close the oven door halfway to the first
opening position. Then lift and pull to remove
the door from its seat.
Step 4
Put the door on a soft cloth on a stable sur‐
face.
Step 5
Hold the door trim (B) on the top edge of the
door at the two sides and push inwards to re‐
lease the clip seal.
Step 6
Pull the door trim to the front to remove it.
Step 7
Hold the door glass panel by its top edge
and carefully pull it out. Make sure the glass
slides out of the supports completely.
Step 8
Clean the glass panels with water and soap. Dry the glass panels carefully. Do not clean the glass
Step 9
If the door is installed correctly, you will hear a click when closing the latches.
The screen-printing zone must face the inner side of
the door. Make sure that after the installation the sur‐
face of the glass panel frame on the screen-printing
zones is not rough when you touch it.
When installed correctly the door trim clicks.
Make sure that you install the internal glass panel in
the seats correctly.
panels in the dishwasher.
After cleaning, install the glass panel and the oven door.
2
B
1
A
ENGLISH
19
Advertisement
Table of Contents
