Table of Contents
Advertisement
en Cleaning and servicing
Reattach the water outlet hose and
5.
secure the connection point using
the hose clamp.
Clean the water inlet filters.
Clean the filter in the water inlet in
the event of blockages or if the water
pressure is too low.
Emptying the water inlet hose
Turn off the tap.
1.
Set a programme, except for
2.
Rinse , Spin or Drain .
Start the programme and leave it
3.
to run for approx. 40 seconds.
Switch off the appliance.
4.
Disconnect the appliance's mains
5.
plug from the power supply.
Cleaning the filter on the tap
Note: Please read the safety informa-
tion → Page 4 to ensure that you use
the appliance safely.
44
Requirement: The water inlet hose is
empty.
Remove the water inlet hose from
1.
the tap.
Clean the filter with a small brush.
2.
Connect the water inlet hose and
3.
check for leaks.
Cleaning the filter on the appliance
Note: Please read the safety informa-
tion → Page 4 to ensure that you use
the appliance safely.
Advertisement
Table of Contents
