Operation - MULTIQUIP WM70SLF Operation Manual

This section is intended to assist the operator with the initial
startup of the mixer. It is extremely important
that this section be read carefully before
attempting to use the mixer in the field.
DO NOT use your mixer until this section is
thoroughly understood.
WARNING
Failure to understand the operation of the mixer could
result in severe personal injury or damage to the mixer.
Refer to Figure 9 and Figure 10 for component locations.
CAUTION
NEVER operate the mixer in a confined
area or enclosed area structure that does
not provide an ample free flow of air.
STARTING THE MIXER
1. Place the fuel valve lever (Figure 17) in the ON position.
OFF
Figure 17. Fuel Valve Lever (ON)
2. If starting a cold engine, place the choke lever
(Figure 18) in the CLOSED position.
CHOKE LEVER
CLOSE
Figure 18. Choke Lever (CLOSED)
PAGE 24 — WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22)
FUEL VALVE
LEVER
ON
OPEN
3. Move the throttle lever (Figure 19) away from the slow
position, about 1/3 of the way toward the fast position.
THROTTLE
Figure 19. Throttle Lever
4. Locate the emergency stop switch (Figure 20) on the
engine cover. Pull this button outward to allow engine
starting.
EMERGENCY
STOP SWITCH
Figure 20. Emergency Stop Switch
(START Position)
5. Turn the engine switch (Figure 21) to the ON position.
ENGINE SWITCH
Figure 21. Engine ON/OFF Switch (ON)

OPERATION

LEVER
FAST SLOW
P U
T O
S H
S T
O P
PULL OUT TO
START
OFF
ON