AEG TR959M4C User Manual page 29

In case of major problems, the acoustic signals operate, the display shows an
error code and the Start/Pauze button may flash continuously:
Error code
Appliance motor overloaded.
Too much laundry or entrap in the
E50
drum.
Internal fail. No communication be‐
tween electronic elements of the
appliance.
E90 or E91
The mains supply is unstable.
EH0
If the display shows other error codes, deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible
solutions.
12.2 Troubleshooting
Problem
The tumble dryer is not connected
to the mains supply.
The door is open.
The tumble dry‐
er does not op‐ The Aan/Uit button was not push‐
erate. ed.
The Start/Pauze button was not
touched.
The appliance is in standby mode.
Possible cause
Possible cause
Remedy
The programme was not comple‐
ted. Remove the laundry from the
drum, set the programme and re‐
start the cycle.
The programme was not finished
properly or the appliance stoped
too early. Switch the appliance off
and on again.
If the error code appears again,
contact the Authorised Service
Centre.
When the appliance is showing
EH0, please wait until main supply
is stable than press start. If the ap‐
pliance pause the cycle without
any indication then press the cycle
start. If the warning will occur
check the power cord / socket in‐
tegrity or main supply.
Remedy
Connect it to the mains socket.
Check the fuse in the fuse box (do‐
mestic installation).
Close the door.
Push the Aan/Uit button.
Touch the Start/Pauze button.
Push the Aan/Uit button.
ENGLISH 29