Table of Contents
Advertisement
12
www.aeg.com
To connect the appliance to enjoy the full
range of features and services you need:
• Wireless network at home with
internet connection enabled.
• Mobile device connected to wireless
network.
Frequency
Protocol
Max power
5.1 QR code on rating plate
QR code can be used in two ways:
• Scan the QR code with the built-in
camera app to download the My AEG
Care application from the App store
on your smart device and follow the
required steps.
• Pairing your smart device with
appliance to simplify the process.
Scan the QR code with QR code
scanner built-in My AEG Care
application.
5.2 Installing My AEG Care
When connecting the tumble dryer to the
application, stand near it with Your smart
device.
Make sure that your smart device is
connected to the wireless network.
1. Go to the App Store on your smart
device or scan QR code (
"QR code on rating plate" ).
2. Download and install App My AEG
Care.
2.412 - 2.472 GHz for
European market
IEEE 802.11b/g/n
< 20dBm
SCANNING...
Mod. xxxxxxxxx
Prod.No.
910000000 00
000V ~ 00Hz 0000 W
00A
00000000
see chapter
3. Make sure you started a Wi-fi
connection in the dryer. If not go to
the section below.
4. Start the application. Select the
country and language and login with
Your email and password. If you do
not have an account, create a new
one following the instructions in My
AEG Care.
5.3 Wireless connection
configuration
Before you begin the configuration
download and install My AEG Care
application on your smart device.
1. Push the Aan/Uit button to switch on
the appliance.
2. Wait approximately 8 seconds.
3. Press and hold the Start via App
button for around 3 seconds until you
hear a single 'click' sound.
The symbols:
and
display. After few seconds only flashing
symbol:
remains. Appliance is
starting up the connection, it takes
around 10 second for the wireless
module to activate. When ready the
symbol:
(Access Point) appears on
the display. Access Point is open for
around 3 minutes.
4. Configure the My AEG Care app on
your smart device and follow the on
screen instructions to connect the
appliance to your WiFi network.
5. If the connection is established,
symbol is off and the
stays lit steadily.
Each time you switch the
appliance on, the appliance
attempt to connect to the
network automatically. When
the connection is established
the symbol:
flashing.
To switch off the wireless connection,
touch and hold down Start via App button
until you hear a single 'click' sound. The
symbol:
appears on the display.
appear on the
WiFi icon
stops
Advertisement
Table of Contents
