Electrolux KNT5NF33W3 User Manual page 16

16 www.electrolux.com
Problem
The compressor does not
start immediately after
pressing the "FastFreeze",
or after changing the tem‐
perature.
Door is misaligned or inter‐
feres with ventilation grill.
Door does not open easily. You attempted to re-open
Side panels of the appli‐
ance are warm.
The lamp does not work.
There is too much frost
and ice.
There is too much frost
and ice on food products in
the refrigerator.
Water flows on the rear
plate of the refrigerator.
Possible cause
The compressor starts af‐
ter a period of time.
The appliance is not level‐
led.
the door immediately after
closing.
This is a normal state
caused by operation of the
heat exchanger.
The lamp is in stand-by
mode.
The lamp is defective.
The door is not closed cor‐
rectly.
The gasket is deformed or
dirty.
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
Appliance is fully loaded
and is set to the lowest
temperature.
Temperature set in the ap‐
pliance is too low and the
ambient temperature is too
high.
Food products are placed
too close to the tempera‐
ture sensor.
During the automatic de‐
frosting process, frost
melts on the rear plate.
Solution
This is normal, no error
has occurred.
Refer to installation instruc‐
tions.
Wait a few seconds be‐
tween closing and re-open‐
ing of the door.
Make sure the appliance
installation is done accord‐
ing to the instructions giv‐
en in this user manual.
Close and open the door.
Contact the nearest Au‐
thorized Service Centre.
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products
better.
Refer to "Control panel"
chapter.
Set a higher temperature.
Refer to "Control panel"
chapter.
Set a higher temperature.
Refer to "Control panel"
chapter.
Keep a distance between
food products and the tem‐
perature sensor (a rectan‐
gular indent in the right
wall of the refrigerator be‐
tween the glass shelves).
This is correct.