Getting Started; After Use - UD 24W5210 User Manual

Connecting the network cable (LAN connection)
You can also establish
an internet connection
via WiFi.

Getting started

Powering the TV set on and off
Powering on
Check that the TV is in standby mode. This means the mains cable must be connected to a
working mains socket.Then press the power button on the device or the
remote to turn on the TV.
Powering off
To power the TV off, either press the Power button on the device or press the
the remote control.

After use

Cleaning
Warning: Make sure the device is unplugged from the mains power before
cleaning. Otherwise, there is a risk of electrocution!
Never spill or spray any type of liquid into the unit. Only use a clean, dry cloth for cleaning
the casing. Never use aggressive liquids. When very dirty, use a slightly dampened cloth.
Clean the screen with a special cleaning cloth for screens.
Caution: when you clean the screen, hold the device steady with one hand
and carefully clean the screen with the other. Otherwise, the device could tip
over and get damaged or cause injuries.
Storage when not in use
If you do not plan to use the device for an extended period of time, unplug the power cord from
the socket and remove the batteries from the remote control. Make sure that the storage
temperature is between 15 °C and 45 °C and the relative humidity does not exceed 90%.
Transport
If you wish to move the device a short distance, proceed as follows to transport the device:
1. Disconnect the device from the mains.
2. Remove all cables connected to the device.
12
button on the
button on