Table of Contents
Advertisement
Programming using the Base Unit
:
Programmable settings
You can customize the unit by programming the following features.
To access the features, there are 2 methods:
– scrolling through the display menus (page 32)
– using the direct commands (page 33)
Some of the features can be programmed through the Web user interface (page 39).
L Direct command is the main method used in this User Guide.
Programming by scrolling through the display menus
1
{MENU} (middle soft key)
2
Press {^}, {V}, {<}, or {>} to select the desired main menu. i {SELECT}
3
Press {V} or {^} to select the desired item in sub-menu 1. i {SELECT}
L In some cases, you may need to select from sub-menu 2. i {SELECT}
4
Press {V} or {^} to select the desired setting. i {SAVE}
L This step may vary depending on the feature being programmed.
L To exit the operation, press {EXIT}.
Note:
L See page 33 for the default settings.
L In the following table, ( ) indicates lines you need to select for the settings.
Main menu
Line status
m
IP service
Ringer settings
(
32
Sub-menu 1
–
Network setting
Call features
Ringer volume
Ringer tone
Interrupt tone
Document Version 2011-03
Sub-menu 2
–
*1
DHCP
*1
IP settings
Embedded web
Call forward
(Line 1: 8 max.)
*1
– Unconditional
*1
– Busy
*1
– No answer
*1
Do not disturb
(Line 1: 8 max.)
*1
Block anonymous
(Line 1: 8 max.)
*1
Block Caller ID
(Line 1: 8 max.)
–
(Line 1: 8 max.)
–
Page
9
–
–
39
35
36
36
37
16
–
–
Advertisement
Table of Contents
