Advertisement
Read and understand thoroughly this safety instructions before use. The items indicated here are very important safety precautions, which must be followed. Any failure and losses caused by ignoring the above mentioned items and cautions mentioned in the operation and installation instruction are not covered by our warranty and any liability.
The appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
Children of less than 3 years should be kept away unless continuously supervised.
The rear surface of appliance shall be placed against a wall.
The appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by a utility.
Possible electric shocks
Possible Explosions
Fire accidents/short circuit or electric leakage may occur
Never stop a tumble dry before the end of the drying cycle unless all items are quicly removed and spread out so that the heat is diddipated.
Personal injury may occur
Other instructions
Connect the appliance
Select the required programme
The selector dial is divided into following sections:
Note:
"" is for the "standard cotton programme". The programme is suitable to dry normal wet cotton laundry and it is the most efficient programme in terms of energy consumption for drying wet cotton laundry.
Automatic controlled drying
The appliance detects the moisture in the load and automatically adjust the drying time for optimal drying. Just select the programme according to fabrics. This drying system holds good for cottons, synthetics sections and Anti-Bacterial, Silk programme.
Time controlled drying
Can be used to finish off drying if necessary. Select the 90 or 60 minute programme for cottons or the 30 programme for synthetics. To cancel a programme which is running, turn the programme selector dial to "off". At the end of drying, turn the selector dial to "off" to switch the machine off before removing the laundry.
Programme Option buttons
Depending on the programme, different functions can be combined. These must be selected after choosing the desired programme and before depressing the Start/Pause button. When these buttons are pressed, the corresponding pilot lights come on. When they are pressed again, the pilot lights go out.
Select the Buzzer
After turning on the appliance, the buzzer is off if you do none operation. The buzzer can be turned on or be turned off during the process. By pressing "Buzzer" button, the buzzer goes off and the corresponding pilot light comes on. When the buzzer is on, the signal will sound in the following cases:
When the buzzer is on, if you press the "buzzer" button once more, the buzzer will be switched off.
Select the Quick button
The option can be selected in the following programme: "Extra", "Cupboard+", "".By depressing this button the drying time will be reduced by 3-5 minutes. The corresponding light illuminates. This option cannot be selected together with "Delicate" option.
Select Delicate
The option can be selected in the following sections: "Cottons", "Synthetics". Pressing this button allows drying to be performed at a lower temperature, for delicate items, the corresponding pilot light comes on. This function cannot be used with QUICK DRYING.
Select Delay start
This button allows you to delay the starting of the programme by 12 hours max. This option must be selected after having selected the programme and before pressing Start/Pause to start the programme. Every time the button is pressed, the time is increased by 1 hour.
It can be selected in both cases before and after selecting option programme (Buzzer, Quick, Delicate). The countdown begins after you have pressed the Start/Pause button and the corresponding light illuminates. The display shows the remaining time. The remaining time is dispalyed hour by hour.
Display
The display shows the following informtion: After you have selected the programme, its duration (in hours and minutes) appears on the display. It is calculated automatically on the basis of the maximum load accepted for each type of fabric and of the required degree of drying. When the programme starts, the remaining time is displayed every 1 minutes.
Select the Start/Pause
Press this button to start the dryer after having selectde the programme and the options. If the door of the appliance is opened while the programme is running, this button must be pressed again after closing the door in order to restart the programme from the point at which it was interrupted. In this case the lights flash to remind you that the start button needs to be pressed again.
Indicator lights
These lights indicate the following functions:
Thermostat reset
If during operation, the heating element doesn't work, maybe the manual thermostat disconnect, first turn the programme selector dial to the position "Air Dry" and press the start button, approximately 20 minutes later, press the thermostat reset button.
At the eand of the programme
All drying programme end with a 5 or 10 minutes cooling phase. If the laundry is not removed at the end of the cycle, the dryer preforms an anti-creasing phase(duration: 30 minutes maximum). If you do not remove the laundry, the dryer will stop automatically at the end of the anti-creasing phase. The display shows"End" and the buzzer sounds for 15 seconds if you have selected the buzzer. Turn the programme selector dial to "off ", all the lights go out.
If the door of the appliance is opened while the programme is running, the "Start" button must be pressed again after closing the door in order to restart the programme fron the point at which it was interrupted.
After each use
Clean the filter.
If the drying programme has to be stopped before it reaches the end, we recommend that you turn the programme selector dial to position "Air Dry" and wait until the end of this cooling phase before removing the laundry. This will avoid a build-up of heat inside the appliance. To do this first turn the dial to "off" and then to "Air Dry" and depress the "Start" button.
Modifying the programme
To change a programme which is running, first cancel it by turning programme selector dial to "off ". Select the new programme and press the "Start" button.
Before loading the laundry
Never tumble dry the following: Particularly delicate items such as net curtains, woolen, silk, fabrics with metal trim, nylon tights, bulky materials such as anoraks, blankets, eiderdowns, sleeping bags, feather quilts and any items containing rubber foam or materials similar to rubber foam.
![]() | maybe tumble dried |
![]() | normal drying (high temperature) |
![]() | delicate drying (low temperature) |
![]() | do not tumble dry |
Make sure that no metal objects are left in the laundry (e.g. hair clips, safety pins, pins)
Button up pillowcases, close zip fasteners, hooks and poppers. Tie any belts or long tapes. To avoid laundry becoming tangled: Close zips, button up duvet covers and tie loose ties or ribbons(e.g.of aprons). Turn items with double-layered fabrics inside out(e.g.with cottonlined anoraks, the cotton layer should be outermost).These fabrics will then dry better. Remove all objects from pockets such as lighters and matches.
Maximum loads
Recommended loads are indicated in the program charts:
General rules:
Cotton, linen: drum full but not too tightly packed;
Synthetics : drum no more than half full;
Delicate fabrics and woollens: drum no more than quarter full.
Try to load the maximum capacity of the machine as small loads are uneconomical.
Laundry weights
The following weights are indicative:
Drying programmes
If the weight of the laundry is less than 1 kg, it is more efficient to dry to select "Time controlled Drying" programme.
You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work.
External cleaning
Use only soap and water and then dry thoroughly. Important: do not use methylated spirit, diluents or similar products.
Cleaning the door
Clean periodically the interior part of the door to remove any fluff. Accurate cleaning ensures correct drying.
Cleaning the filter
The "End" light and "Filter" light are lighting for long time after the program is finished, the light are indicating end user to clear the filter.
The filter must be removed for cleaning. (See picture)
Do not use the appliance without filter.
Malfunction | Possible cause | Solution |
Dryer does not work |
|
|
Drying results unsatisfactory |
|
|
Drum light does not work |
|
|
Drying cycle ends shortly after programme starts. "End" light illuminated. |
|
|
Drying cycle lasts; an unusually long time |
|
|
If you are unable to identify or solve the problem, contact our service center. Before telephoning, make a note of the model, serial number and purchase date of your machine: the Service Center will require this information.
If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.
Dryer Model | PTD-F7-W |
Dry Capacity (kg) | 7.0 |
Electrical connection Voltage-Overall power-Fuse | Information on the electrical connection is given on the rating plate |
Depth with loading door open (mm) | 1030 |
Power(left-on mode)(W) | 0.42 |
Power(off mode)(W) | 0 |
Energy consuption at full load(kWh) | 5.75 |
Programme time at full load(min) | 217 |
Dimensions(W*D*H) (mm) | 595*555*850 |
Note : All the above data in the table came out base on "" which tested according to En61121:2013 standard. These data may be different because of different laundry type, residual moisture, environmental conditions and voltage fluctuation.
It is dangerous to alter the specificati ons or attempt to modify this product in any way.
care must be taken to ensure that the a ppliance does not stand on the electrical supply cable.
Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.
The appliance must not bulit-in.
Should the appliance be moved, it must be transported vertically.
Accessory | Name | Quantity |
![]() | Vent Hose | 1 |
![]() | Manual | 1 |
It is recommended that, for your convenience, the machine is positioned close to your washing machine. Whilst drying, the tumble dryer will expel a certain amount of warm, very moist air, and this should be removed from the room as quickly as possible to prevent condensation. In an extremely well ventilated room or close to an open window, this may occur naturally. However, in general, it is better to carry the dryer's exhaust outside via the vent hose supplied with the appliance; ending either temporarily at an open window, or permanently at a fixed ventilation grille, fitted to an exterior wall or window. The tumble dryer must be installed in a clean place, where dirt does not build up. Make sure there are no obstructing items or material near the air-intake louvres provided at the back(e.g.paper, rags etc). To keep vibration and noise to a minimum when the dryer is in use, it should be placed on a firm, level surface.
Note
If the floor is uneven, adjust the adjustable feet. Do not put any wooden pieces or other objects under foot bases.
When pushing down the edges of the dryer top plate diagonally, the machine should not move up and down at all.(please check both of two directions) if the machine rocks when pushing the machine top plate diagonally, adjust the feet again.
Note
The locknuts must be tightened after adjustment.
Any looseness can cause vibration and noise.
The feet must nevet be removed. Do not restrict the floor clearance through deep pile carpets, strips of wood or similar. This might cause heat build-up which would interfere with the operation of the appliance.
The hot air emitted by the tumble dryer can reach temperatures of up to 60°C. The appliance must there not be installed in floors which are not resistant to high temperatures.
To simplify the installation, there is a choice of vent outlets: one at the back, the other in the left hand side. Connect the hose to whichever is the more convenient by pulling the ring nut (A)from the vent outlet at the back, aligning arrows of hose and ring nut, fastening by screwing hose to the direction of arrow and pushing it firmly back into place. The unused vents should now be sealed with the special snap cover(B)provided.
Advice:
If the hose is long and the room temperature low, the moisture might condense inside the hose. This is an unavoidable natural phenomenon. To prevent this water from lying in the hose or flowing back into the tumble dryer, it is advisable to drill small hole (dia.3 mm) in the lowest point of the hose and to place a small container below it. (See picture, point B).
Once connected to the dryer, run the vent hose to the desired outlet point, it contains no more than two bends. As to the outlet itself, if you have decided on a fixed wall/window grille, a good local builder's merchant should be able to supply you with the necessary fittings and installation advice.
It is important not to connect the vent hose to, for example, a cooker hood, or a chimney or flue pipe designed to carry the exhaust from a fuel burning appliance. Note that to avoid condensation problems, it is essential that the dryer be fitted with the flexible hose to carry its auste outside the kitchen. In order to prevent the appliance from overheating, it is important that the steam exhaust is unobstructed. If the dryer is fitted next to kitchen units, make sure that the vent hose is not squashed. If the hose is partially squashed, drying efficiency will be reduced, resulting in longer drying times and higher energy consumption. If the hose is completely squashed, the safety cut-outs with which the machine is fitted may operate.
Electrical connection
Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.
THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should this safety measure not be observed. Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance's rating plate. Should the plug need to be replaced for any reason, proceed as described below. The wires in the mains lead are coloured in accordance with the following code:
The wire coloured green and yellow must be connected to the terminal marked with the letter earth symbol or coloured green and yellow.
To save energy and to help protect the environ ment, we recommend that you follow these hints:
Try to load the maximum capacity of the machine as small loads are uneconomical.
This guarantee does not cover
Damage or calls resulting from transportation, improper use or neglect, the replacement of any light bulbs or removable parts of glass or plastic. Appliances found to be in use within a commercial environment, plus those which are subject to rental agreements. Products of our manufacture which are not marketed by us.
Marking explanation
V | Volt | ~ | Alternating current | ||
W | Watt | Hz | Hertz | ||
![]() | Tested safety | ![]() | CE marking | ![]() | risk of fire |
Oil-affected items can ignite spontaneously, especially when exposed to heat sources such as in a tumble dryer. The items become warm, causing an oxidation reaction in the oil. Oxidation creates heat. If the heat cannot escape, the items can become hot enough to catch fire. Piling, stacking or storing oil-affected items can prevent heat from escaping and so create a fire hazard. If it is unavoidable that fabrics that contain vegetable or cooking oil or have been contaminated by hair care products be placed in a tumble dryer they should first be washed in hot water with extra detergent - this will reduce, but not eliminate, the hazard.
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Parmco PTD-F7-W - Washing Machine Installation And Operating Instructions
Advertisement
Need help?
Do you have a question about the PTD-F7-W and is the answer not in the manual?
Questions and answers