Preparing The Remote Controller (Only For Kd-S6250) - JVC KD-S6250 Instructions Manual

Preparing the remote controller
This section is ONLY FOR KD-S6250.
Before using the remote controller:
• Aim the remote controller directly at the remote
sensor on the main unit. Make sure there is no
obstacle in between.
Remote sensor
• Do not expose the remote sensor to strong light
(direct sunlight or artificial lighting).
Installing the battery
When the controllable range or effectiveness of
the remote controller decreases, replace the
battery.
1
Remove the battery holder.
1) Push out the battery holder in the direction
indicated by the arrow using a ball point
pen or a similar tool.
2) Remove the battery holder.
(back side)
2
Place the battery.
Slide the battery into the holder with the +
side facing upwards so that the battery is fixed
in the holder.
6
1)
2)
Lithium coin battery
(product number:
CR2025)
3
Return the battery holder.
Insert again the battery holder pushing it until
you hear a clicking sound.
(back side)
WARNING:
• Store the batteries in a place which children
cannot reach.
If a child accidentally swallows the battery,
consult a doctor immediately.
• Do not recharge, short, disassemble or heat the
batteries or dispose it in a fire.
Doing any of these things may cause the
batteries to give off heat, crack or start a fire.
• Do not leave the batteries with other metallic
materials.
Doing this may cause the batteries to give off
heat, crack or start a fire.
• When throwing away or saving the batteries,
wrap it in tape and insulate; otherwise, the
batteries may start to give off heat, crack or start
a fire.
• Do not poke the batteries with tweezers or
similar tools.
Doing this may cause the batteries to give off
heat, crack or start a fire.